Filter
Top Products
_,_NSTALLATION INSTRUCTIONS, CONT.
How TO REPLACE THE
DOOR AND HINGES
I. Install center hinge with Phillips
screws.
2. Install stabilizing brackets with _" hex
head screws.
3. Replace center
hinge pin.
4. Place hinge side of
refrigerator door on center hinge pin.
5. While holding 2.
refrigerator door
upright, tighten 3.
down top hinge 4.
with Y_"hex head
driver.
6. Install top door trim of fresh food
door with a Phillipsscrewdriver.
How TO INSTALL AND
REMOVE PANELS
(SOME MODELS)
TO INSTALL PANELS:
I. Perform the handle removal
instructions in How to Install and
Remove the Handles, including
instructions to remove mounting
posts from door face.
Remove top door trim.
Remove handle side door trim.
,
Slidepanelinthe handlesideofdoor,
byusinggroovesprovided by bottom
door capandsidedoor trim.
Replace mounting posts, handles,and
trim.
TO REMOVE PANELS:
I. Perform the handle
2,
3.
4.
removal
instructionsin How to Install and
Remove the Handles, including
instructions to remove mounting
postsfrom door face.
Removetop doortrim.
Removehandlesidedoor trim.
Slide panel out the handleside of
door.
WHAT IF I AM
INSTALLING RAISED
PANELS?
Pleaseseerecommendeddimensionsfor
paneling.All panelholesare ¼ dtameten
2679-
73cm
H
How Do I MOUNT
HANDLESON RAISED
PANELS?
The refrigerator is shipped with the
handle mounting posts attached to the
door with ¼" hex head screw that is
approximately 1½" long.This length is
necessaryto safely secure the mounting
post to the door.
Ifhandlesarebeingmountedto a raised
surface,the factory supplied hex head
screws will haveto be replacedwith a
longerversion.To determinehow long
the replacementscrewmusthe,addthe
thicknessof the raisedpanelto the 1½"
measurementSeeexamplebelow.
1½" k_ng _" hex_-_ (factory
i ,_mlL_
I" thick raised
panel = 2½ long