Filter
Top Products
6
Cont.
PART PROCEDURE
CAUTION
Cleaning Procedures
• Be sure appliance is off and all parts are cool before handling
or cleaning. This is to avoid damage and possible burns.
• To prevent staining or discoloration, clean appliance after each use.
• If a part is removed, be sure it is correctly replaced.
Control Panel • To activate control lock for cleaning, see Locking the Control, page 16.
• Wipe with damp cloth. Dry thoroughly.
• Glass cleaners may be used if sprayed on a cloth first. DO NOT spray directly on control pads and
display area.
• Do not use other cleaning sprays, abrasive cleaners or large amounts of water on the panel.
Control Knobs • Remove knobs in the OFF position by pulling forward.
• Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish.
• Turn on each element to be sure the knobs have been correctly replaced.
Cooktop – Never use oven cleaners, chlorine bleach, ammonia or glass cleaners with ammonia.
Glass-Ceramic Important: Call an authorized servicer if the glass-ceramic top should crack, break or if metal or
aluminum foil should melt on the cooktop.
• Allow the cooktop to cool before cleaning.
• General – Clean cooktop after each use, or when needed, with a damp paper towel and Cooktop Cleaning
Creme* (Part No. 20000001)**. Then buff with a clean, dry cloth.
Important: Permanent stains will develop if soil is allowed to cook on by repeatedly using the cooktop when
soiled.
• Heavy Soils or Metal Marks – Dampen a “scratchless” or “never scratch” scrubber sponge. Apply
Cooktop Cleaning Creme* and scrub to remove as much soil as possible. Apply a thin layer of the creme over
the soil, cover with a damp paper towel and let stand 30 to 45 minutes (2-3 hours for very heavy soil). Keep
moist by covering the paper towel with plastic wrap. Scrub again, then buff with a clean, dry cloth.
Important: Only use a CLEAN, DAMP “scratchless” pad that is safe for non-stick cookware. The pattern and
glass will be damaged if the pad is not damp, if the pad is soiled, or if another type of pad is used.
• Burned-On or Crusty Soils – Scrub with a “scratchless” or “never scratch” scouring pad and
Cooktop Cleaning Creme*.
Important: Hold a razor blade scraper at 30
°
angle and scrape any remaining soil. Then, clean as described
above. Do not use the razor blade for daily cleaning as it may wear the pattern on the glass.
• Melted Sugar or Plastic – Immediately turn element to LOW and scrape sugar or plastic
from hot surface to a cool area. Then turn element OFF and allow to cool. Clean residue
with razor blade scraper and Cooktop Cleaning Creme*.
Oven Window • Avoid using excessive amounts of water which may seep under or behind glass causing staining.
and Door - • Wash with soap and water. Rinse with clear water and dry. Glass cleaner can be used if sprayed on a
Glass cloth first.
• Do not use abrasive materials such as scouring pads, steel wool or powdered cleaners as they will
scratch glass.
Oven Interior • Follow instructions on pages 4-5 to set a self-clean cycle.
Oven Racks • Clean with soapy water.
• Remove stubborn soil with cleansing powder or soap-filled scouring pad. Rinse and dry.
• Racks will permanently discolor and may not slide smoothly if left in the oven during a self-clean operation.
If this occurs, wipe the rack edge and rack support with a small amount of vegetable oil to restore ease
of movement, then wipe off excess oil.
* Brand names are registered trademarks of the
respective manufacturers.
** To order call 1-800-JENNAIR (1-800-536-6247).
8113P631-60 5/3/06, 8:52 AM7