Jenn-Air GAS WALL OVEN Oven User Manual


 
6
OVEN COOKING
Baking Notes:
To change the oven temperature during cooking, press
Bake, then press the Autoset 0 or appropriate number
pads until the desired temperature is displayed.
To change the oven temperature during preheat, press
the Bake pad twice, then press the Autoset 0 pad or
appropriate number pads until the desired temperature is
displayed.
If you forget to turn off the oven, it will automatically turn
off at the end of 12 hours. If you wish to deactivate this
feature, see page 9.
Baking
To set Bake:
1. Press the Bake pad.
BAKE and 000 will flash in the display.
2. Select the oven temperature. Press the Autoset 0 pad for
350° F or the appropriate number pads.
Each additional press of the Autoset 0 pad will increase
the temperature by 25°.
The oven temperature can be set from 170° to 550°.
3. Press Bake pad again or wait four seconds.
BAKE will stop flashing and light in the display.
Baking Differences Between Your Old
and New Oven
It is normal to notice some baking time differences between a
new oven and an old one. See “Adjusting the Oven Temperature”
on page 10.
100° or the actual oven temperature if over 100° F will
display. It will rise in 5° increments until the preset
temperature is reached.
4. Allow the oven to preheat for 8-15 minutes.
When the set oven temperature is reached, one long
beep will sound.
The set temperature will display.
To recall set temperature during preheat, press Bake pad.
5. Place food in the oven.
6. Check cooking progress at the minimum cooking time.
Cook longer if needed.
7. When cooking is finished, press CANCEL pad.
8. Remove food from the oven.
Cook & Hold
When using the Cook & Hold option, the oven begins to heat
immediately after the control has been set. Then, the oven
cooks for a specified length of time. When that time has
elapsed, the oven will keep the food warm for up to an hour
then automatically turn off.
To set Cook & Hold:
1. Press the Cook & Hold pad.
HOLD will flash to indicate that you are in Cook &
Hold programming.
00:00 will flash in the display.
2. Select the amount of time you want to cook by using the
number pads.
HOLD continues to flash.
The time will light in the display.
Time can be set from 10 minutes (00:10) to
11 hours, 59 minutes (11:59).
3. Press the Bake pad and select the oven
temperature. Press the Autoset 0 pad for 350° F
or the appropriate number pads.
BAKE will flash.
The oven temperature can be set from 170° F to 550° F.
4. Press the Bake pad again OR wait four seconds.
BAKE will remain lit.
The cooking time will show in the display.
The actual oven temperature will be displayed
during preheat.
The set temperature will display when the oven is
preheated.
When the cooking time has elapsed:
Four beeps will sound.
HOLD and WARM will light.
170° will display.
Time of day will display.
8112P336-60 8/10/06, 2:21 PM7