Filter
Top Products
19
Replace Oven Bake Burner Cover
1. Align rear shoulder screw mounting holes (keyholes) on the
oven bake burner cover with shoulder screws in the bottom
of the oven.
2. Drop cover and slide to left or right to slide shoulder screws
into narrow ends of keyholes and lock into place.
To Convert Surface Burners
1. If the burner grates are installed, remove them.
2. Remove burner cap.
3. Remove the burner base.
4. Apply masking tape to the end of a 7 mm nut driver to help
hold the gas orifice spud in the nut driver while changing it.
Insert nut driver into the gas opening and press down onto
the gas orifice spud and remove by turning the gas orifice
spud counterclockwise and lifting out. Set gas orifice spud
aside.
5. Replace with correct LP gas orifice spud. See the “LP Gas
Orifice Spud/Hood Chart.”
Use the following chart to find the exact orifice spud
placement.
Fully insert choke into bottom of medium burner base. Choke
should snap into place.
LP Gas Orifice Spud/Hood Chart
6. Place Natural gas orifice in plastic parts bag for future use
and keep with package containing literature.
7. Replace the burner base.
8. Replace burner cap.
9. Repeat steps 2 through 8 for the remaining burners.
10. Unplug range or disconnect power.
11. Remove the control knobs.
A. Shoulder screw mounting holes (keyholes)
B. Shoulder screws
A.Bake burner cover
Large Dual Burner
A. Burner cap
B.Burner base
Medium Burner
A. Burner cap
B.Burner base
C.Choke (for use with medium
burner, LP gas only)
Small Burner
A. Burner cap
B.Burner base
B
A
A
A
B
A
B
C
A
B
Burner
Rating
Color Size Burner Style
3,000 BTU Blue 0.55 mm Small burners
11,000 BTU Yellow 0.97 mm Medium burners
14,000 BTU Red/
Green
1.05 mm
0.35 mm
Large burner - main
Large burner - simmer
14,500 BTU Black 1.18 mm Grill burner
Burner orifice spud
A. Size stamp or color
A