Filter
Top Products
21
Operation
Before attempting any operation
with your miter saw, make sure that you have
read and thoroughly understand the warnings
contained on pages 5-6 and the Compound
Miter Saw Safety section on page 7. Failure to
comply may result in serious injury!
Starting a cut
1. Place hands at least 8-3/4 in. away from the
path of the blade.
2. Hold workpiece firmly against the fence to
prevent movement toward the blade.
3. Bring the saw blade down to the workpiece to
see the cutting path of the blade.
4. Squeeze the trigger switch (A, Fig. 23) to start saw.
5. Lower blade into workpiece with a firm
downward motion.
Finishing a cut
1. Hold the cutting arm in the down position.
2. Release trigger switch (A, Fig. 23) and wait for
all moving parts to stop before moving your
hands and raising the cutting arm.
3. If the blade does not stop within 10 seconds,
unplug the saw and follow the instructions in
the Troubleshooting section.
Jammed Material
1. Release trigger switch.
2. Wait for all moving parts to stop.
3. Unplug the miter saw.
To Turn the Saw On
Depress the trigger switch (A, Fig. 23).
Note: Make the On/Off switch child-proof by
inserting a padlock through the hole (B, Fig. 23) in
the trigger switch.
The miter saw is equipped with an automatic blade
brake. When the trigger switch is released, the
electric blade brake will stop the blade within
approximately 10 seconds.
Figure 23
A
B
C