John Lewis JLBIDW 1201 Dishwasher User Manual


 
Select and start a washing
programme
Starting the washing
programme
1. Switch on the appliance. Make sure that
the appliance is in setting mode.
2. Select a washing programme. Refer to
'Washing programmes'.
The related programme indicator
comes on.
3. Close the appliance door, the washing
programme starts automatically.
Warning! Interrupt or cancel a
washing programme in progress only
if it’s absolutely necessary. Hot steam
may escape when the appliance door
is opened. Open the door carefully.
Interrupting a washing
programme in progress
1. Open the appliance door. The washing
programme stops.
2. Close the appliance door. The
programme continues from the point at
which it was interrupted.
Cancelling the washing
programme
If the washing programme has not yet
started, you can change the selection.
When a washing programme is in progress,
you cannot change the selection. You have
to cancel the programme to make a new
selection.
1. Press and hold the Start/Cancel button
until the indicator of the programme in
progress goes off and the End indicator
starts to flash.
2. Release the Start/Cancel button, the
washing programme has been cancelled.
Make sure that there is detergent in
the detergent dispenser before you
start a new washing programme.
End of the washing
programme
When the washing programme is
completed, an intermittent acoustic signal
sounds.
1. Open the appliance door.
The End indicator is on.
2. Switch off the appliance.
Leave the door ajar and wait a few
minutes before removing the dishes.
In this way they will be cooler and
the drying will be improved.
It is recommended that the appliance
is unplugged and the water tap
turned off when the washing
programme is completed.
18