Filter
Top Products
14
"Fast Heat Up" function"Fast Heat Up" function
"Fast Heat Up" function"Fast Heat Up" function
"Fast Heat Up" function
After a cooking function has been selected and the temperature has
been adjusted, the cavity will gradually heat up until the selected
temperature is reached. This will take from 10 to 15 minutes,
depending on selected function and temperature.
If it is necessary to reach the required temperature in a shorter time,
the "Fast Heat Up" Function can be used.
1) Switch the oven on by pressing button
.
2) Set the required cooking function and temperature as explained
in the previous pages.
3) Set the temperature by pressing button
“ “
or
“ “. The
temperature will appear on the display.
4) Press button Fast heat up . The temperature display will show
"FHU" (Fig. 18).
5) press button
Oven function and the symbol
“
°°
°°
°”
will flash for
approximately 10 seconds. Now it is possible to select the
required temperature by pressing button
“ “
or
“ “.
4) When the required temperature is reached, an acoustic alarm
will sound for a short time, and the temperature display will
revert to the set temperature.
This function can be used with any cooking function or temperature.
Demo modeDemo mode
Demo modeDemo mode
Demo mode
This mode is intended to be used in the shops to demonstrate
the oven functionality without any power consumption except
the oven lamp. To activate this function the appliance should be
in stand-by mode.
—
Press button Fast heat up and
“ “
for approximately 2
seconds (Fig. 19).
An acoustic alarm will sound for a
short time
.
—
Press button and the “
idid
idid
id
” indication will appear in the
display.
All oven functions can be selected.
The thermometer symbol
will flash as “
idid
idid
id
” indication and
number digits.
Follow the Follow the
Follow the Follow the
Follow the
above describedabove described
above describedabove described
above described
procedure to d procedure to d
procedure to d procedure to d
procedure to d
is-is-
is-is-
is-
ableable
ableable
able
the demo mode. the demo mode.
the demo mode. the demo mode.
the demo mode.
ErEr
ErEr
Er
rr
rr
r
or codeor code
or codeor code
or code
The electronic programmer does a continuous diagnostic check
of the system. If some parameters are not correct, the control
unit will stop the activated functions and it will show on the
display the corresponding error code.
For further details, refer to chapter "Something not work-
ing“ on page 22.
Fig. 18Fig. 18
Fig. 18Fig. 18
Fig. 18
Fig. 19Fig. 19
Fig. 19Fig. 19
Fig. 19
"Beep" Mode"Beep" Mode
"Beep" Mode"Beep" Mode
"Beep" Mode
You can choose to make The Electronic Control beep each
time that a control is touched.
To enable this function, the oven must be off.
1.Press controls Oven functions and “ “ at the same time
for about 3 seconds. The Electronic Control beeps once
To disable the "Beep" Function:To disable the "Beep" Function:
To disable the "Beep" Function:To disable the "Beep" Function:
To disable the "Beep" Function:
1.If the oven is on, press button to switch it off.
2.Press controls Oven functions and “ “ at the same time
for about 3 seconds. The Electronic Control beeps once