Filter
Top Products
7
How to Finish Unpacking
• Place packed appliance next to the space in
which it will be installed.
• Remove the appliance packing except for
bottom tray which should be left in position until
the appliance is ready to be fitted into its
cabinet.
NOTE: It is imperative that the appliance is
left in the base to protect both the appliance
and the floor.
• Ensure the owner is given these operating
instructions.
Important: Switch off at mains,
miniature circuit breaker and if
appropriate, remove fuse before
commencing any electrical work.
To Remove Cover of Mains
Terminal
From the rear of the appliance, remove mains input
terminal cover to gain access to terminal block.
• First remove retaining screw with pozidrive
screwdriver. See Fig. 8.
• Prise cover loose using screwdriver in position
(1) then lever off with screwdriver in position
(2) at either side. See Fig. 9.
• Lift cover and remove screw from cable clamp.
See Fig. 10.
Fig. 8
Fig.9
Fig.10