Filter
Top Products
9
Building In
IMPORTANT: Ensure that the oven is
switched off at the wall before any
further work is carried out.
• Position the appliance in front of the cabinet.
See Fig. 12.
• Take out all oven furniture before installation to
reduce the weight you need to lift. The oven
door should be taped up to keep it closed.
• To place the appliance into the space between
cabinetry follow the procedure below:
• N.B. Two people will be required to carry
out the lifting procedure.
Warning: Do not attempt to lift this
appliance by the handle(s).
• Each person should squat either side of the
appliance.
• Tilt the appliance so that your hands can support
the underside of the appliance.
• Keeping your back straight, raise the appliance
to the correct height by straightening at the
knees.
• Rest the rear underside of the appliance on the
mounting brackets while your hands support the
front.
• The appliance can be pushed fully into the space.
Take care to avoid damaging the mains lead.
• Ensure the appliance is central and level.
• When the appliance is fully housed, screw the
stability screws (supplied with the appliance) into
the underside of the work surface in the
positions indicated (see Fig. 13), taking care not
to distort the trim. It is advisable to turn each
screw alternatively to avoid damaging the trim.
• Place the heat deflector flush with the edge of
the work surface with the cork spacers up over
(see Fig.14) and screw into position using the
screws supplied with the appliance. Failure to do
this may cause damage to the underside of the
work surface.
• Replace the plinth board.
• Switch on the appliance and refer the user to
the operating instructions.
Fi
g
.13
Fi
g
.14
Fig. 12