Filter
Top Products
26
What to do if...
Remedying Small Malfunctions
In the event of a fault, the light signal at floor level flashes.
If the acoustic signal is activated, warning tones sound if there are
faults.
If one of the following fault codes is displayed in the multi-display dur-
ing operation:
– Fault codeÅ10 (Problems with water inlet),
– Fault codeÅ20 (Problems with water drainage),
please have a look at the following table.
When the fault is remedied, press the button for the cycle that has
started. The cycle will continue.
With other fault codes (“Å ” followed by a number):
– Cancel the dishwashing cycle.
– Switch the appliance off and on again.
– Re-set the dishwashing cycle.
If the fault is displayed again, please contact your local Service Force
Centre and inform them of the fault code.
Malfunction Possible cause Remedy
1 short warning tone
continuously repeated can
be heard,
the cycle indicator for the
selected dishwashing cycle
is flashing:
fault code
Å10 is dis-
played in the multi-dis-
play:
(Problems with water in-
let)
Water tap is blocked with
limescale or faulty.
Check the water tap and
have it repaired if necessary.
The tap is turned off. Turn the tap on.
The filter (where present) in
the threaded hose fitting
on the tap is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the
dishwasher compartment
are blocked.
Press the button for the
commenced dishwashing
cycle;
then cancel the dishwashing
cycle (see section: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Water inlet hose
has not been correctly posi-
tioned.
Check the position of the
hose.