Filter
Top Products
• machine is NOT placed on a surface which is sensitive to
heat, water and steam.
• Plug-in machine.
6.1 TURNING THE MACHINE ON
• Press the On/Off button on top of the machine (Fig 1,2).
The display will illuminate. FILL WATER TANK
6.2 FILLING THE WATER TANK
Please note: Only use fresh, cold water. Never fill water tank
with carbonated water, milk or any other liquid.
• Remove the water tank (Fig. 1.1), rinse and fill with fresh, cold
water.
• Replace water tank and close lid. Display shows
OPEN TAP.
• Place a cup underneath the frother and turn the Selector
Switch to the hot water/steam position (Fig. 5). The display
shows
SYSTEM FILLING. The ENA starts pumping water into
the system, until water comes through the frother. After a few
seconds the process stops and the display shows CLOSE
TAP
. Turn Selector Switch to the coffee position. HEATING.
• Place a cup underneath the coffee spout. After approx. one
minute the display shows PRESS ROTARY.
• Push down on the Rotary Dial (Fig.4). Warm water pumps
through the coffee spouts and stops. Display shows
READY.
6.3 ABOUT COFFEE BEANS
Frozen Beans: Thaw 3 to 4 hours before adding to bean
container. This prevents moisture from seeping into the grinder.
Oily Beans: Beans with an oily surface tend to stick together.
This may prevent a continuous flow of beans from the bean
container into the burrs. As a result the grinder does not grind
enough coffee and you might get weak or no coffee at all.
Before filling oily beans into the bean container pour the beans
in an open bowl and let them sit for about 5 hours. The oils will
evaporate (this will not change the taste of your coffee). Then fill
the beans into the bean container. Now beans will feed into the
burr grinder more easily.
Flavored Coffee: DO NOT use flavored beans in the grinder!
If you like flavored coffees we recommend to add flavors to your
coffee after brewing. This way you can use your regular coffee
beans in the bean container. Adding the flavors after brewing
lets you control the intensity better than with pre-flavored coffee.
Your local coffee store typically carries a variety of flavors.
6.4 FILLING THE BEAN CONTAINER
Please note: To insure that your conical burr grinder will work
for a long time, do not use it with any kind of coated or flavored
beans (all coating and flavors contain sugar or sugar substances).
Such coating can damage the burrs. Using such beans voids the
warranty. Have your coffee store grind the sugar coated beans
and use as described in the chapter 10.
• Remove the Bean Container Lid (Fig. 1, 3).
• Fill beans into the bean container. The container holds approxi-
mately 4 oz. (125g) of beans.
• Place an 8 oz. cup underneath the Dual Coffee Spout and
push the Rotary Dial. During coffee preparation the display
sequence changes as follows:
READY... NORMAL... 1 CUP...
READY.
• If the display shows FILL BEANS push the Rotary Dial again.
• Discard the first two cups of coffee.
READY. Your next cup of
coffee will be perfect.
13.