Filter
Top Products
1. Push and hold the P button (Fig. 4) until the display shows
RINSE.
2. Turn the Rotary Dial until the display shows
PRODUCT.
3. Push the Rotary Dial. The display shows WATER.
4. Push the Rotary Dial again. The display shows 5.0 OZ.
5. Turn the Rotary Dial until the display shows 3.0 OZ.
6. Push the Rotary Dial to confirm. The display shows
OK and
then WATER. You have now set the coffee volume for 1 CUP
to 3 oz. Note: when using the 2-cup setting the ENA will now
produce a total of 6 oz.
7. Turn the Rotary Dial to
FLAVOUR and push the
Rotary Dial. The display shows NORMAL.
8. Turn the Rotary Dial until the display shows STRONG and
push the Rotary Dial to confirm. The display shows
OK and
then FLAVOUR.
9. Turn the Rotary Dial until the display shows TEMP.
10. Push the Rotary Dial. The display shows HIGH.
11. Turn the Rotary Dial until the display shows
NORMAL and
push to confirm. The display shows OK and then TEMP.
You have now re-programmed all three settings.
12. Push the P button to return to READY.
14b. VISUAL PROGRAMMING OF CUP SIZE
You can also reprogram the cup size visually. READY.
• Place the cup underneath the coffee spout.
• Press and hold down the Rotary Dial until the display reads
ENOUGH COFFEE? Then let go. The ENA starts grinding and
brewing coffee.
• When the desired amount of coffee is in your cup push the
Rotary Dial again. The display shows
OK and then READY.
This is now the new programmed volume for the one cup size.
15. WATER CARE
Water is heated inside the machine, this leads to calcium
deposits forming. The ENA works with:
• regular tap water • bottled water • distilled water.
We recommend using regular tap water or bottled water. Distilled
water has no minerals and does not improve the taste of coffee.
Tap water has a varying degree of water hardness (chapter 16).
Most bottled water has a low level of water hardness.
IMPORTANT: do not use carbonated water or any other liquid in
the water tank.
You have the following options to take care of the water.
• Decalcifying System (chapter 18.3).
• Clearyl Water Filter Cartridge (chapter 17.1).
Your machine is pre-set in the factory to automatically remind
you to decalcify. You can change the water hardness setting to
comply with the water you are using (chapter 16.1).
Please note: The machine will automatically remind you when it
is necessary to run certain water maintenance programs. It is
important that you follow those instructions. Otherwise your
machine may not function properly.
16. WATER HARDNESS MONITOR
Your ENA is set to a water hardness of 10ºdH. The ENA will
remind you when it is time to perform a decalcifying cycle. You
can change the water hardness setting from 1 to 30dH. If you
are not sure about the hardness of your water, ask your local
water company for the "Water Hardness in Grains." The machine
displays the water hardness in the German hardness scale which
is a bit different from the American "Grain" scale (see chart
below). You can also use the enclosed water hardness indicator
21.