Jura Capresso ENA 3 Coffeemaker User Manual


 
12a. USING THE DUAL FROTHER PLUS
ENA 3 and 4 only: The Dual Frother Plus is already attached.
ENA 5 only: Remove the frothXpress (Fig. 20), and attach the
Dual Frother to the steam nozzle. Make sure it is pushed up
completely against the steam nozzle (Fig. 17).
Caution: If the Dual Frother is not attached properly or it is
clogged (see chapter 12b) it is possible that the frother can be
pushed off during steaming. This can cause burns and injuries.
Frothing Position: The cylinder of the frother is pushed down.
Steaming Position: The cylinder is pushed up (see Fig. 15).
READY
• Turn the Rotary Dial until the display shows STEAM.
• Push the Rotary Dial. The display shows HEATING. The ENA
takes about 15 to 30 seconds to increase the temperature of
the thermoblock system from hot water to steam.
• Fill the desired amount of milk into a pitcher or in your cup.
Make sure that the pitcher or the cup has at least twice the
volume of the milk, e.g. if you steam or froth 5 oz. of milk use a
10 to 12 oz. pitcher.
• When the display shows
READY, immerse the frother into the
milk (Fig. 16) and turn the Selector Switch to the hot water/
steam position. The display shows
STEAM. Steam will be
injected into the milk.
• With the cylinder pushed down (Fig. 15) small frothing bubbles
will build up on the surface.
• With the cylinder pushed up, steam will heat up the milk with
out creating froth.
IMPORTANT:
When you are finished with frothing/steaming turn the Selector
Switch back to the coffee position. The display shows
READY.
Steam output will stop. Now remove the pitcher or the cup from
the frother.
Please note: Within the next 40 seconds you can steam/froth
more milk by simply turning the Selector switch back to the
steaming position.
Tips for frothing (Cappuccino):
The frother tip should not touch the bottom of your pitcher.
Start in the steaming position – cylinder "up" (Fig. 15) – for a
few seconds. Then push the cylinder "down". Milk froth will
build up. This way the froth on top of your milk is also warm.
• Steaming and frothing directly in your cappuccino/latte cup:
With practice, you can steam and froth directly in your
cappuccino cup. First steam and froth the milk, then add your
espresso shot.
Hotter milk?
If the frothed milk is not hot enough, continue in the steaming
position.
12b. CLEANING THE DUAL FROTHER PLUS
Always keep the Dual Frother Plus clean. The two side holes and
the groove of the frother tip must be free of milk deposits (Fig. 18).
If these parts contain hardened milk particles, it will be impossible
to froth milk properly.
Fast cleaning:
READY. Place a cup underneath the frother and turn the
17.