Jura Capresso ENA 3 Coffeemaker User Manual


 
Since the Water Hardness Selector is off, the machine will not
remind you when to decalcify. This could clog and damage your
machine.
17.3 MANUAL CLEARYL REPLACEMENT
If the filter is more than 2 months old and the display does not
indicate to replace filter, replace as follows.
READY.
• Push and hold the P button until the display shows RINSE
• Push the button again. The display shows again RINSE
• Turn the Rotary Dial until the display shows FILTER
• Push the Rotary Dial. The display shows INSERT FILTER
• Continue with steps 3 to 12 in chapter 17.2 above.
17.4 DO NOT LET THE CLEARYL FILTER DRY OUT!
If the filter is not immersed in water for a few days the granular
inside will dry out and will block any water from passing through.
• If machine is not used for a few days, always leave some water
in the water tank. This way the filter will not dry out. Once you
start using the machine again, fill the water tank with fresh
water and process approx. 2 oz. of water through the hot
water spout. Now you have fresh water for your first cup of
coffee.
• If the machine is not used for a longer period of time, empty
the water container and remove the CLEARYL filter. Fill a glass
with at least 2 inches of water and immerse the filter. Place the
glass in the refrigerator.
• When you use the machine again, install the filter.
18. AUTOMATIC CLEANING CYCLES
18.1 CLEANING WITH SPECIAL TABLET
The machine monitors how many coffees are brewed and how
often the rinsing program is activated. After approx. 180 coffees
or 80 initial rinse cycles the display will show
CLEAN / READY.
You can continue to make coffee, however we highly recom-
mend cleaning the machine as described below within the next
few days. This cleaning program will remove oil build-ups in the
brewing chamber. It takes only about 15 minutes. Use the
enclosed white cleaning tablet. The machine comes with a pack
of 2 tablets. To re-order see chapter 31.
Important: Once the cleaning program has started do not
interrupt the procedure.
CLEAN / READY
Make sure the water tank is at least half full.
1. Press the Rinse button (Fig. 4). Display shows
EMPTY TRAY
2. Remove the complete drawer with the grid and the used
coffee container (Fig. 1, 12 to 14) and empty the tray and the
used coffee container. Note: Even if tray is empty it must be
removed for 20 seconds.
3. Replace the complete assembly.
4. The display shows
PRESS ROTARY
5. Place a cup underneath the coffee spouts and push the
Rotary Dial. The display shows CLEANING and water comes
through the coffee spouts. This process stops after a few
times and the display shows ADD TABLET.
6. Open the pre-ground coffee chute and drop in one white
cleaning tablet (Fig. 24).
7. Close the pre-ground coffee chute. The display shows
PRESS ROTARY.
8. Push the Rotary Dial. The display shows
CLEANING. The
machine starts the automatic cleaning program by dispensing
water in intervals in the cup underneath the coffee spout. The
program stops automatically and the display shows
24.