Jura Capresso ENA 3 Coffeemaker User Manual


 
READY
1. Open the cover behind the Rotary Dial. (Fig. 1,5)
2. Push and hold the P button (Fig. 4) until the display shows
RINSE.
3. Turn the Rotary Dial until the display show FILTER –
4. Push the Rotary Dial. The display shows NO –
5. Turn the Rotary until the display shows YES
6. Push the Rotary dial again to confirm. The display shows OK
and then INSERT FILTER
7. Remove the Clearyl cartridge from its bag and rinse cartridge
under water.
8. Remove the water tank, open the Clearyl filter holder (Fig. 6)
and insert the cartridge with its tapered end down into the
water container. Make sure it fits securely inside the fins.
9. Push down the Clearyl holder until it snaps in (Fig. 7).
10. Fill the water tank with fresh cold water and replace.
11. Place a 20 oz. container under the steam nozzle (Fig. 17).
12. Push the Rotary Dial. The display shows
OPEN TAP.
13. Turn the Selector Switch to the hot water/steam position.
FILTER RINSING. Approx. 16 oz of cold water is pushed
through the filter and through the steam nozzle. The rinsing
water might be slightly discolored. This is not harmful and
does not affect the taste of your next coffee. The rinsing
stops automatically. The display shows
CLOSE TAP.
14. Turn the Selector Switch back to the coffee position.
HEATING. READY.
The filter is now activated.
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
17.2 AUTOMATIC CLEARYL REPLACEMENT
Eventually the filter needs to be replaced. Over time and
depending on the amount of water, the filter will cease to work.
The machine cannot monitor the time aspect. It monitors the
water volume. After approx. 60 liters of water use (~2,000 oz.)
the display shows alternating
READY FILTER
1. Open the cover behind the Rotary Dial. (Fig. 1,5)
2. Press the Rinse button (Fig. 4). The display shows INSERT
FILTER
3. Remove and empty the water tank.
4. Open the filter holder (Fig. 6) and remove the old cartridge.
5. Remove the new Clearyl cartridge from its bag and rinse
under water.
6. Insert the cartridge with its tapered end down into the water
container. Make sure it fits securely inside the fins.
7. Push down the Clearyl holder until it snaps in (Fig. 7).
8. Fill the water tank with fresh cold water and replace.
9. Place a 20 oz. container under the steam nozzle (Fig. 17).
10.Push the Rotary Dial. The display shows
OPEN TAP.
11.Turn the Selector Switch to the hot water/steam position.
FILTER RINSING. Approx. 16 oz of cold water is pushed
through the filter and through the steam nozzle. The rinsing
stops automatically. The display shows
CLOSE TAP.
12. Turn the Selector Switch back to the coffee position.
HEATING. READY.
Important: If the filter is older than two months it needs to be
replaced, regardless how much water has been processed (see
chapter 16.3). At that time the filter has lost its calcium sup-
pressing abilities and calcium will build up inside the machine.
23.