Jura Capresso ENA 3 Coffeemaker User Manual


 
RINSE.
• Turn the Rotary Dial until the display shows LANGUAGE
• Push the Rotary Dial ENGLISH
• Turn the Rotary Dial to ESPANOL
• Push the Rotary Dial to confirm: OK, IDIOMA (Language)
• Push the P button to leave the programming mode. LISTO
(ready).
23. KEEPING YOUR MACHINE IN TOP SHAPE
Keeping your ENA in good working condition will maintain
the taste and aroma of your coffee beverages.
• Start the day with fresh, cold water.
• Don’t fill more beans into the bean container than you use in
two or three days. Store the rest of your beans in a dry dark
place. Oxygen, light, heat and moisture diminish the aroma of
the coffee beans.
• If you have not used your machine for a few days, brew one
short coffee and discard. The next cup will taste much better.
• Always pre-warm your cup with hot water (chapter 9a).
• Keep the coffee spouts as close as possible to the cups to
maximize crema.
24. CLEANING THE BEAN CONTAINER
Coffee oils may build up inside the bean container. These oils
may reduce the taste of your coffee. Too much oil hinders the
beans from flowing freely into the grinder. Clean the bean con-
tainer from time to time. Wait until the bean container is empty.
• Turn off the machine.
• Remove the bean container lid and clean the inside with a dry,
soft cloth.
25. CLEANING THE INSIDE OF THE MACHINE
• Turn off machine and let cool down for 10 minutes.
• Remove the complete drawer. Wipe the inside of the machine
with a paper towel.
• Replace the complete drawer.
26. EMPTYING SYSTEM BEFORE TRANSPORT
To avoid frost damage during transport you must empty the
system as follows:
Caution: this procedure produces hot steam!
READY
• Place a cup underneath the steam nozzle.
• Turn the Rotary Dial until the display shows STEAM.
Push the Rotary Dial. The display shows HEATING.
• When the display shows
READY, turn the Selector Switch to
the Steam/Water position. Steam is discharged.
• Now remove the water tank. Steam will continue through the
steam nozzle for several seconds until the display shows
CLOSE TAP.
• Press the on/off button to turn the machine off (Fig. 1, 2).
• Turn the Selector Switch back to the Coffee position.
Important: the next time you use the machine follow the instruc-
tion in chapter 6.1 and 6.2
27. DISPLAY MESSAGES
EMPTY TRAY or EMPTY GROUNDS.
The drawer or used coffee container is full. Remove complete
drawer and empty all parts.
Please note: After each coffee brewing, ENA discards the used
coffee into the used coffee container (Fig. 1.14) and a bit of
28.