Filter
Top Products
• Never fill frozen beans into the bean container. If you store
beans in the freezer, let them thaw 3 to 4 hours before filling
them into the bean container.
• Never fill anything other than coffee beans into the bean
container (no chocolate, rice, nuts, spices, etc.)
• Never fill anything but fresh, cold clean water into the water
container, except when decalcifying (chapter 18.3).
• Never use mineral or carbonated water. You can use tap
water, bottled water, spring water, distilled water and reverse
osmosis water.
• Never repair or open the machine yourself. All repairs should
be performed only by an authorized service center.
• Do not place the machine on a surface which is sensitive to
hot or cold water and steam.
PLEASE, DO...
• Fill water tank with fresh, cold water only.
• Remove any foreign particles (small stones) from coffee beans.
• Let frozen beans thaw 3 to 4 hours before pouring them into
the bean container.
5. FACTORY SETTINGS
Each machine leaves the factory with the following pre-sets:
• 1 Cup –
5 OZ., temp. HIGH, coffee strength (flavor): NORMAL
• 2 Cups – 5 oz.(per cup), temp. HIGH, strength (flavor) STRONG
ADJUSTABLE SETTINGS
1 cup from 0.5 to 8 oz.
2 cups from 0.5 to 8 oz. per cup
Note: when using the 2-cup option, ENA will always grind in the
STRONG setting.
Please note: You can change all above pre-sets (chapter 14a).
You can also override the strengths and the cup size before/
during actual brewing. Overriding will not change the preset
values (chapter 9d).
Other functions are set as follows (to change functions refer to
listed chapters.)
Filter (Clearyl)...................– not installed ..... 17.1
Hardness Level............... 10º dH.................. 16.1
Auto-Off.......................... 2 Hours................. 20
Grinder Fineness ............Middle position .... 7
Energy Saving ................ – not set.............. 19
Unit (Volume) ................ in OZ ................... 21
Language ....................... English ................. 22
3-Color Display
The ENA features a 3-color alpha-numeric display. This facilitates
the use even more.
Green: ENA is ready to prepare a beverage or is in the process
of preparing a beverage.
Red: ENA is requiring some kind of action from you to get back
to the green display (e.g. FILL WATER TANK)
Yellow: ENA is in programming mode (you pushed the P button).
To get out of the programming mode, push the P button again
and the display will show the previous information.
6. PREPARING ENA FOR THE FIRST TIME
Make sure
• all accessories, literature, caution leaflets etc. are removed
from the machine, the water tank, and the bean container.
• the Clearyl Water Filter is NOT installed!
• the machine sits on a flat, even surface and the drawer, tray
and used coffee container are inserted (Fig. 1, 12-13).
12.
chapter