Filter
Top Products
25.
EMPTY TRAY.
9. Remove the cup and then the drawer and tray.
10.Empty drawer and ground coffee container and replace.
11.The display shows
READY.
The machine will automatically remind you after the next 180
cups of coffee to repeat this cycle.
18.2 MANUAL TABLET CLEANING CYCLE
It is possible that the brewing process slows down before the
automatic message (chapter 18.1) appears. Dark beans may
deposit more oils into the brewing chamber. When this happens
you can manually start a tablet cleaning cycle as follows:
READY
• Push and hold the P button (Fig. 4) until display shows RINSE.
• Push the P button again. The display shows again RINSE.
• Turn the Rotary Dial until the display shows
CLEAN.
• Push the Rotary Dial EMPTY TRAY
Continue with steps 2 through 11 in chapter 18.1
18.3 DECALCIFYING
The ENA has an integrated decalcifying program. This decalcify-
ing program takes about 40 minutes. Your ENA is set in the fac-
tory to automatically remind you when it is time to decalcify the
machine. If you do not use the Clearyl filter, we recommend that
you purchase one set of Jura decalcifying tablets (one set is
good for three decalcifying procedures). See chapter 31.
Please note: If you have installed and activated the Clearyl filter,
the decalcifying program is inactive.
DECALCIFYING AGENT: Only use our special decalcifying
tablets Model # 66281, chapter 31.
CAUTION:
• Avoid contact of the descaling agent with the skin or eyes.
This can cause irritation. Rinse the descaling agent off with
clear, clean water. Should you get descaling agent in your
eyes, consult a doctor.
• Immediately remove any splashes or drops of the decalcifying
agent from sensitive surfaces, such as natural stone or wood.
• Always wait until the decalcifying agent in the water tank has
been used up. Do not fill additional decalcifying agent into
the water tank.
• Never use vinegar or any other decalcifying agent. This might
damage internal parts of the machine.
When the display shows
DE-SCALE / READY it is time to
decalcify the machine. You can still make coffee. However, it is
highly recommended decalcifying the machine within the next 3
to 4 days.
Important: CLEARYL FILTER: If you use the Clearyl water
cartridge and the display shows DE-SCALE / READY, then your
cartridge function was not activated. Follow the instructions in
chapter 17.1 to activate a new cartridge.
Important: The decalcifying program must not be interrupted.
DE-SCALE / READY
1. Remove the Dual Frother or the frothXpress from the steam
nozzle (Fig. 17).
2. Open the cover behind the Rotary Dial and press the Rinse
button (Fig. 4) The display shows
EMPTY TRAY.
3. Remove the complete drawer with the grid and the used
coffee container (Fig. 1, 12 to 14) and empty the tray and the
used coffee container.