Filter
Top Products
13
Ⅲ Switch on machine by pressing button.
Ⅲ Push button for about 3 seconds. Warning lamps ,
(if necessary) , light up.
Ⅲ Fill water tank.
Ⅲ Empty drip tray and grounds container and replace them. War-
ning lamps (if necessary) go out.
Ⅲ Place a container under the coffee-spout (9).
Ⅲ Put a Jura cleaning tablet (Fig. 9) into the powder funnel (10).
Ⅲ Press selector button . The warning lamp goes out.
Warning lamp flashes.
The flashing of warning lamp indicates that the cleaning
process is activated.
Ⅲ If warning lamp lights up, empty drip tray (if necessary),
wait about 10 seconds before replacing it. Warning lamp
goes out.
Ⅲ Replace the container under the coffee-spout (9) and press button
.
The cleaning process is continued.
Ⅲ If warning lamp lights up again, empty drip tray (if neces-
sary), wait about 10 seconds before replacing it. Warning lamp
goes out.
Ⅲ Replace the container under the coffee-spout (9) and press button
.
The cleaning process is continued. At the end of it, warning lamp
lights up.
Ⅲ Empty drip tray and grounds container and replace them.
Warning lamp lights up.
Ⅲ Replace container under the coffee spout (9) and press button
. The machine rinses and warning lamp lights up.
Tip: Clean powder funnel with a bottle-brush.
13. Decalcifying
Your machine has an integrated decalcifying program. If a Claris fil-
ter cartridge is used there is no need for decalcifying your machine.
Please use Jura decalcifying tablets only. These are available from
your Jura dealer
Note: If the machine needs decalcifying warning lamp
lights up. You can still draw off coffee and hot-water/steam
and run the decalcifying program later.
Important: Run the decalcifying program only after the ma-
chine has been switched off for at least 2 hours and has
cooled down completely. The decalcifying program is started
with the machine switched off. The running decalcifying
program must not be interrupted.
Ⅲ Switch off machine by pressing button and let the machine
cool down for 2 hours.
Ⅲ Then remove water tank.
Ⅲ Press button for about 3 seconds. Warning lamps , ,
light up.
Ⅲ Pour 0,5 litres of water into a container and completely dissolve
the contents of a blister pack (2 tablets). Then fill the mixture in-
to the water tank.
Ⅲ Empty drip tray and replace it. Warning lamps , , ,
flash and warning lamp lights up.
Ⅲ Place a sufficiently big container under the pivoting nozzle (13).
Turn selector switch for hot-water/steam (12) to position .
E