Filter
Top Products
8
Ⅲ You have the following possibilities to adjust the grade of grinding
the smaller the dots, the finer the grinding
the bigger the dots, the coarser the grinding
Important: The grinding grade should only be adjusted while
the grinder is working.
3.6 Adjusting for water hardness
The water is heated inside the machine. With use, this leads to
calcium deposits (furring) forming on the machine. This is automa-
tically indicated in the display. For this reason, it is necessary to
adjust the machine to the hardness of your local water before you
use it for the first time. Use the enclosed test-sticks for this purpose.
Note: 1° water hardness on the German scale represents
1.79° on the French scale.
The machine has got 5 hardness settings to choose from. The
chosen grade is shown on the display.
Legend: = flashes
= lights up
Level 0 = Setting for Claris filter
cartridges Display
The display for automatic
decalcifying is switched off.
Level 1
German water hardness 1° – 7°
French water hardness 1.79° – 12.53°
Level 2
German water hardness 8° – 15°
French water hardness 14.32° – 26.85°
Level 3
German water hardness 16° – 23°
French water hardness 28.64° – 41.14°
Level 4
German water hardness 24° – 30°
French water hardness 42.96° – 53.7°
The machine is adjusted to Level 3 before it leaves the factory.
You can alter this setting by simply following the instructions
below:
Ⅲ Pull the mains lead with its plug out from the cable box at the
rear of the machine.
Ⅲ Put the mains plug into the wall socket.
Ⅲ Leave the machine switched off.
Ⅲ Press the button for about 3 seconds. Now warning lamp
(Level 3) flashes.
Ⅲ Choose the required setting by pressing button and press
button to store in memory. The warning lamps go out.