Filter
Top Products
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don’t change
the page numbering. Keep the language integrity.
Back cover page (last page)
Assembly page 7/12
Fax +32 2 359 95 50
• Once the steaming time is over, the appliance comes back
directly to “holding” mode. Time & are displayed and a green
pilot light goes on. At the end of the steaming time, the holding
mode keeps the food warm (every 8 minutes the food is warmed
for two minutes)
• Press “0/I” button to stop steaming and return back to clock mode.
PROGRAMMATION OF THE APPLIANCE
Press the “PROG” button. is displayed. Press “+” or “-” to
set the moment when you want your appliance to start.
Caution: this setting determines at what time you want your
appliance to start. For example, it is 6 PM, you want your appliance
to start at 7 pm, you have to set the timer at 7:00 PM. Mind the
indication PM for the afternoon settings, there is no indication for
“AM” settings.
Each press increases or decreases the beginning of steaming time by
10 minutes. You can set your appliance up to 24 hours in advance.
Press once again the “PROG” button. is displayed. You
can set the steaming time by pressing on the “+” or “-” button. Each
press on the “+” or “-” button increases or decreases the steaming
time by five minutes. Press once again on “PROG”. Time and “PROG”
are displayed. The timer is then set (NOTE : if you want to cancel the
programmation, press on “PROG” one more time, and the “PROG”
symbol on the display will go out.).
Now your appliance is in “programmation” mode. Once the set hour
has come, you hear a beep and a red pilot light goes on. The
appliance starts to steam according to your settings. If you want to
cancel the “programmation” during steaming, press the “0/I” button,
the appliance shuts down and comes back to clock mode.
Once the steaming is over, the appliance comes back to “holding”
mode, the symbol is displayed and a green pilot light goes on.
Every 8 minutes, the holding mode warms the food for 2 minutes
after the end of cooking time.
Press “0/1” to come back to the clock mode.
Whatever the mode (steaming, programmation, holding…) the
appliance stops automatically once all the water has run out.