Filter
Top Products
7
Using Your PowerMix Stand Mixer
Before First Use
Before first use, remove all
promotional stickers and packaging
material. Wash the stainless steel
mixing bowl, beaters and dough
hooks in warm soapy water with a
soft cloth. Rinse and dry thoroughly.
The stainless steel mixing bowl may be
washed in the dishwasher.
NOTE: When first using your
stand mixer, you may notice
an odour from the motor. This is
normal and will dissipate as the
motor is run in.
Attaching the Beaters/
Dough Hooks
1. Place the mixer and mixer stand
on a level, dry surface such as a
bench top. Ensure the mixer stand
arm is in the horizontal position.
2. Attach the beaters/dough hooks
to the mixer before it is placed
onto the mixer stand.
3. Insert each beater/dough hooks
shaft into the left and right beater
sockets underneath the mixer
(Fig. 1). Ensure the beater, with the
white cog wheel collar is inserted
into the socket with the cog wheel
pattern. This is important to drive
the stainless steel mixing bowl.
Fig. 1
4. Insert the beaters/dough hooks by
pushing the shaft into the socket,
turning slightly if required until they
lock into place.
Attaching the Mixer to the
Mixer Stand
1. To attach the mixer to the mixer
stand, position the mixer motor on
the stand so that the back of the
mixer aligns with the back of the
arm stand.
2. Press the mixer down on the
stand until the latch clicks into the
locking position (Fig. 2).
Fig. 2
NOTE: The beater/dough hook
with the white cog wheel collar
should be in the correct socket
so that it aligns with the cog
wheel gear on the mixer stand.
If not placed correctly, the bowl
will not turn.
WARNING: Ensure the
mixer is switched off
and unplugged from
the power outlet before
attaching the beaters to
the mixer.