Keating Of Chicago 240V Pasta Maker User Manual


 
11
COMMON PROBLEMS SOLUTIONS (FOLLOW IN SEQUENCE)
Water always filling 1. Clean sensors thoroughly with brush and vinegar.
2. Adjust the sensitivity of the B Board (for the top sensor) fully clockwise.
3. If filling persists, ground out the top sensor (if filling stops, replace sensor –
Part #010212).
4. If filling persists after grounding the sensor, replace the B Board (Part
#001166).
Water never fills 1. Turn water switch (far right) ‘on.’
2. Clean sensors thoroughly with the brush and vinegar.
3. Adjust the sensitivity of the B Board (for the top sensor) fully counter
clockwise (follow instruction sheet).
4. Remove the wire from the top sensor. If filling begins, replace sensor (Part #
010212).
5. If water does not fill, place a jumper wire across terminals A & C on the B
Board. If filling begins, replace B Board (Part # 001166).
6. If water does not fill, replace water solenoid (Part # 008133).
Timers counting down in the
wrong mode (not minutes or
seconds)
1. Reset the timer (see instructions).
Water leaking in the rear of
the pasta cooker
1. Replace fill hose (Part #033495 – sold per foot)
Breakers continue to trip 1. Ensure all wires to the contactors, breakers and elements are tight.
2. Verify water is not getting on any components.
3. Check contactors for proper operation.
4. Check continuity on elements.
5. Replace breaker.
Heating elements won’t
come on
1. Verify operating instructions in the manual.
2. Clean sensors with brush and vinegar.
3. Adjust sensitivity of the A Board (for the lower sensor) fully clockwise (follow
instruction sheet).
4. Place the wire attached to the lower sensor to the ground (if heating begins,
replace sensor – Part #010212).
5. If heating does not being, place a jumper wire across terminals A&C on the A
Board. If heating begins, replace the A Board (Part #001167).
VI SERVICE DIAGNOSIS
TROUBLE SHOOTING
The following diagnosis is only to be used as a guide to qualified service personnel. Keating recommends that
you use a qualified service company. Call 1-800-KEATING if you need assistance in locating a qualified service
company.