Filter
Top Products
CHOPPING cent.
NOTE: Before opening the Bowl Cover Assembly, turn the unit OFF and unplug
the cord,
g To remove bow_ cover, unlock by turning¢_ockwise untti cover unialches, and lilt all.
10 Lilt the chopping blade by its base and remove. Unlock the Bow! by turning it clockwise,
(see Assembly on pages 4 and 5), and lift off. Emply the processed food
WARNING: Chopping Blade is very sharp, Use caution when handling, _1
TO SLICE OR SHRED:
_ AUTION: Make sure control knob switch is turned to OFFend unit Is |
unplugged before use. Never use your hand to push food into processor,
J
The use of heavy pressure wtl! not speed operation.
1 Lock the Bowl onto the Base as described in Assembly
2 Slide the disc slem down onto the center post of the base, then piace the sllce/shred
disc, with the desired side facing up for either slicing or shredding, onto the disc stem
and push down At this point the disc will be at the top of the bow]
_ ARNING: Slicing/Shredding Disc is very sharp, Use caution when
handling.
3o Lock the Food Pusher onto the movable loop by rotating counterclockwise until tab is
under slot in the !top's lid At this point, Ihe movable Ioep works as part of the Iced pusher
Lock Ihe Bowl Cover Assembly onto the Bowl. Open fhe Food Chute Lid by pulling out
the siide button, and iitt up and out on the loop/food pusher (see Fig 3 and 3a), and ieave
in the open posilion
4 Fill the food chute wilh pieces oI Iced such as potalo, cabbage, green pepper, whets
tomato=sic, and look the food chula lid. See the Shredding or Slicing Guide for sizes
of food pleces
5 Close food chute lid and latch into place. Plug the power cord intoelectric outlet Green
Power light and green OFF light should illuminate to show that the food processoris
properly assembled and ready to operate