Filter
Top Products
Tempermre
Advanced Temperature Control (se eotModels)
FREEZER •
8_ _4_ ¸
00 REFRIG_R:ATOR
The control is located at the top front of the fresh food compartment.
@
Initial Tempe_ture Se_ing
F @
Temperatures are preset at the facto_ at 38° (3 C}
in the fresh food compartment and 0° F (q7 ° C} in the
freezer cornpartmenL
Adjusting the Control
24 hours after adding foo& you may decide that one
or both compartments should be colder or warmer. If
so, adjust the control as indicated in the Temperature
Control Guide below.
- The first touch of the (£-, or :.?:'2pads shows the
current temperature setting.
, The display will show the new setting for
approximately three seconds, and then return to the
actual temperature currently within that
compartment
• Do not change either control more than one degree
at a time. Allow temperature to stabilize for 24 hours
before making a new temperature adiustmenL
Temperature Control Guide
Refrigerator too cold Set the Refrigerator control
to next higher number by
. pressing the _;_i) pa&
Refrigerator too Set the Refrigerator control
warm to next lower number by
Freezer too cold
Freezer too warm
Turn refrigerator OFF
pressing the _v) pad.
Set the Freezer control to
next higher number by
pressing the (_) pad.
Set the Freezer control to
next lower number by
pressing tt_e (v) pad.
Press the Freezer (_i pad
until OFF appears in the
display° Press either the
Freezer or Refrigerator _*Z_)
pad to turn back on.
Quick C_bes
When activated, Quick Cubes reduces tt3e
freezer temperature to the optimum setting for
24 hours in order to produce more ice,
Important: When the Quick Cubes feature is in
........ (" "operation, the _,_ and <vi pads for the freezer control
will not operate.
Reset Filter [select models)
• Q
When a water filter has been installed in the
refrigerator, the yellow Order light will illuminate
when g0 percent of the volume of water for
which the filter is rated has passed through the
filter OR 11 months have elapsed since the filter has
been instafled.
The red Replace light will illuminate when the rated
volume of water has passed through the filter OR 12
months have elapsed since the filter was installed. A
new filter should be installed immediately when the
Replace light is illuminated.
After replacing the filter, press and hold the Reset
Filter pad for three ([3] seconds. The Order and
Replace lights will go off.
Vacation Mode [select models)
The Vacation Mode feature causes the freezer to _;,_
defrost less frequently, consen4ng energy: The
Vacation Mode indicator light will illuminate when the
feature is activated. To deactivate, press the Vacation
Mode pad again OR open either door. The indicator
light will go out.
Notes:
, Door openings will not deactivate Vacation Mode
for approximately one hour aRer activation.
if vacationing for more than a few days, see the
Prepanng for Vacation section, page 2&
_3