Filter
Top Products
6. Disconnect wire harness on top of
refrigerator door top Mnge.
• Release two-pin connector by
pressing junction point with a
fiat blade screwdriver or
fingernail.
• Green ground wire remains
attact_ed to the hinge,
Z Unscrew ._i" hex head screws from
top hinge to remove hinge and
retain for later use.
8. Remove Phillips screws to remove
right and left hinges and retain aii
screws for later use.
9. Remove both stabilizing
brackets with :_," hex head
ddver and retain screws for
later use.
Pullout Freezer Drawer
To prevent accidental cMId entrapment or
suffocation risk, do not remove the divider in the
top freezer basket.
To avoid electrical shock, whicil can cause severe
personal injury or death, disconnect power to
refrigerator before removing doors. After repfacing
doors_ connect power.
To avoid possible injury, product, or" prope_y
damage, you will need two people to perform the
following instructions.
Materials Needed:
, Phillips screwdriver
To Remove:
t. Pull drawer open to full
extension.
2. Tilt the lower basket
fop_Jard and lift to remove.
3. Lift top of drawer front to
unhook the drawer from
the slides. Lift door front
out to remove.
To Install:
1. Pu!I both rai!s out to
full extension,
2. While supporting
door front, I_ook
suppo_s into slots
located on inside of
each slide.
I NOte; All four drawel bracket supports must be inthe proper slots for the drawer to function properly,
3. Lower door front into final position,
4. Tilt the lower basket
front down and set it
down into tile basket
cradles.