Filter
Top Products
Automatic ice Maker
Connect the ice maker to the water supply as
instructed on pages 10-11. Proper water flow and a
level refrigerator are essential for optimal ice
maker performance.
Operating instructions
* Confirm ice bin is in place and sensor arm is down.
* After freezer section reaches between 0° to 2° F
(-17° to -16 ° C), ice maker fills with water and begins
operating. You will have a complete harvest of ice
approximately every three hours.
* Allow approximately 24 hours after
installation to receive first harvest of
ice.
* Discard ice created within first 12
hours of operation to assure system is flushed of
impurities.
* Stop ice production by raising sensor arm until click
is heard.
* Ice maker will remain in the off position until sensor
arm is pushed down.
* The first one or two batches will probably contain
undersized and irregular cubes because of air in the
supply line.
* When the ice cubes are ejected it is normal for
several cubes to be joined together at the ends. They
can easily be broken apart. The ice maker will
continue to make ice until the supply of ice cubes
raises the sensor arm, shutting the ice maker off.
* Certain sounds may accompany the various cycles of
the ice maker. The motor may have a slight hum, the
cubes will rattle as they fall into an empty storage
pan and the water valve may click or "buzz"
occasionally. These sounds are normal.
* If the ice is not used frequently, the ice cubes will
become cloudy, shrink, stick together and taste stale.
Empty the ice storage bin periodically and wash it in
lukewarm water. Be sure to dry the bin thoroughly
before replacing it.
* Beverages and foods should not be placed in the
ice storage bin for quick chilling. These items can
block the sensor arm, causing the ice maker to
malfunction.
* Turn off (arm up) the ice maker when the water
supply is to be shut off for several hours.
To Remove the Ice Bin:
* Pull it forward, away from the ice maker. To avoid the
ice maker dumping ice while the bin is removed, turn
the ice maker off by raising the sensor arm.
To Install the Ice Bin:
* Reverse the above procedure. Turn the ice maker on
by lowering the sensor arm.
To avoid personal injury or property damage,
observe the following:
* Do not place fingers or hands o=1the automatic
ice making mechanism while the refrigerator is
plugged in. This will help protect you from possible
injury. It will also prevent interference with moving
parts of the ejector mechanism and the heating
element that releases the cubes.
Under certain rare circumstances, ice cubes may
be discolored, usually appearing with a green-
bluish hue. The cause of this unusual discoloration
can be a combination of factors such as certain
characteristics of local waters, household
plumbing and the accumulation of copper salts in
an inactive water supply line which feeds the ice
maker. Continued consumption of such discolored
ice cubes may be injurious to health. If such
discoloration is observed, discard the ice cubes
and contact your dealer to purchase and install a
water line filter.
Water damage due to improper water connection
may cause mold/mildew growth.
Clean up water and ice spills to avoid personal
injury and to prevent mold/mildew growth.
To Dispense Water:
* Hold container under spout and
press dispenser pad.
Water DispeRser (select models)
The Water Dispenser is located on the
left side wall of the fresh food section. "4:rp-JI
This design is for cold water
dispensing only.
17