Filter
Top Products
SECTION 2 HOW YOUR WATER FILTER WORKS
A. FACEPLATE TIMER FEATURES
The default settings for backwash (25 minutes) and
fast rinse (5 minutes) cycles of regeneration are fac-
tory set for maximum performance of the filter. Use
the following procedures to check for correct cycle
times, or to change if desired. However, only
trained technicians should change the time set-
tings.
ADJUSTABLE BACKWASH
Press and hold the SELECT button until the display
shows "000--", then press the SELECT button once
to advance to the Backwash time adjust screen.
TIME
Using the UP or DOWN buttons, adjust the back-
wash time from 0 minutes to 60 minutes.
ADJUSTABLE FAST RINSE
Press and hold the SELECT button until the display
shows "000- -", then press the SELECT button twice
to advance to the Fast Rinse time adjust screen.
TIMER "POWER-OUTAGE MEMORY"
If electrical power to the timer is interrupted, the
"memory" built into timer circuitry keeps time for 6
hours (minimum) or more. The display is blank and
the filter will not regenerate. When electrical power
comes on, one of two things will happen.
lo
o
The present time of day will show steady, mean-
ing the timer has not lost time.
The display will show a time, but it will be flash-
ing. The timer memory did not keep the time
setting and must be reset (page 1-3). If you do
not reset the time, regenerations will most likely
be at the wrong time of day.
NOTE: The flashing display is to remind you to reset
the timer.
NOTE: If the filter was in a recharge when power
was lost, it will now finish the cycle.
Using the UP or DOWN buttons, adjust the fast
rinse time from 0 minutes to 60 minutes.
2-2
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line