Filter
Top Products
SECTION 1 IWATER FILTER START UP
C. PROGRAM THE TIMER
display
/
/
A
UP button
SDecia!_v Filtr_'_
V
\
i "> \ 2r
RECHARGE button
°J
DOWN button
SELECT button
When the transformer is plugged into the electrical
outlet a model code is displayed for a few seconds
followed by a test number (example: J1.1). Then,
12:00 PM and the words PRESENT TIME will begin
to flash in the time display.
1. SET PRESENT TIME OF DAY
Press the UP or DOWN buttons to set the present
time. Press UP to move the display ahead; press
DOWN to move the time backward.
a. If the present time is between noon and mid-
night, be sure PM shows.
Notes:
If shows in the display, press the UP or
DOWN button until SPF shows in the display. Then,
press the SELECT button to set, and change to the
flashing PRESENT TIME display.
To check the model code, unplug the transformer at
the wall outlet and plug in again, if other than this
code (SPF) shows, see page 5-2 to reset.
b. If the present time is between midnight and
noon, be sure AM shows.
If the words PRESENT TIME do not show in the dis-
play, press the SELECT button (Figure 2) until they
do.
SOUND "BEEPER": A "beeper" sounds while
pressing buttons for set-up. One beep signals a
change in the face plate display. Repeated beeps
mean the timer will not accept a change from the
button you have pressed, telling you to use another
button.
Each press of the UP or DOWN buttons changes
the time by 1 minute. Holding the buttons in
changes the time 32 minutes each second.
1-3
C. Press the SELECT button once to set the present
time of day and advance to the next set up
screen.
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line