Filter
Top Products
12
Suggested 10 place setting loading patterns
Fold-down tines
You can fold down one row of tines at the back of the bottom
rack.
1. Grasp the tip of the tine that is in the tine holder.
2. Gently pull the tine out of the tine holder.
3. Lay the row of tines down in the rack to make room for larger
dishes, bowls, pots, pans or roasters.
Knife holder
Use the knife holder on the left side of the bottom rack to hold
knives that are too large for the silverware basket. Place knives in
the holder as shown.
To remove the knife holder
1. Slide up to release the hooks over the rack wire.
2. Lift knife holder out of rack.
To install the knife holder
1. Align the knife holder with the bottom rack as shown in the
illustration below.
2. Place the bottom slotted guide over the vertical wire in the
side of the rack.
3. Place the hooks, located on the back of the knife holder, over
the center rack wire and gently push down to lock into place.
Loading Silverware Basket
Load the silverware basket while it is in the bottom rack or take
the basket out for loading on a counter or table.
NOTE: Unload or remove the basket before unloading the racks
to avoid spilling water droplets onto the silverware.
■ Place small items such as baby bottle caps, jar lids, corncob
holders, etc., in a covered section. Close the cover to hold
small items in place.
■ Use suggested loading patterns, as shown, to increase
washability of your silverware. Load items using the slots with
the covers down to avoid silverware nesting.
■ This silverware basket can be separated and placed into the
bottom rack in several locations. Load silverware in all
sections or just one, depending upon your load.
■ If your silverware basket does not have covers or when
covers are up, mix items in each section of the basket with
some pointing up and some down to avoid nesting. Spray
cannot reach nested items.
IMPORTANT: Always load items (knives, skewers, etc.) pointing
down.
TURBOZONE™ 10 place setting top rack load
T
URBOZONE™ 10 place setting bottom rack load
A.Top alignment
B.Bottom slotted guide
C.Knife holder hooks
A
B
C