Filter
Top Products
Setting Oven Controls
Setting the Clock
The _ pad is used to set the clock. The clock may be set for 12 or 24 hour time of day
operation. The clock has been preset at the factory for the 12 hour operation. When the
range Jsfirst plugged in, or when the power supply to the range has been interrupted, the
timer in the display will flash (See Fig. 1).
Figure 1
iNSTRUCTIONS
To set the clock (example below for 1:30)
1. Press @. "CLO" will appear in the display (Figure 2).
2. Press (_ (_) @ pads to set the time of day to 1:30
(Figure 3). "CLO" will stay in the display. Press START"CLO"
will disappear and the clock will start (Figure 4).
Changing between 12 or 24 hour time of day display
1. Press and hold _ for 7 seconds• "CLO" will appear in the
display. "12h" (Figure 5) or "24h" (Figure 6) appears in the
display and the control beeps once.
2. Press _ to switch between the 12 and 24 hour time of day
display. The display will show either "12h" (Figure 5) or "24h"
(Figure 6).
3. Press : START'to accept the change or press _ to reject the
change•
4. Reset the correct time as described JnTo set the Clock above•
Please note that Jfthe 24 hour time of day mode was chosen,
the clock will now display time from 0:00 through 23:59 hours•
PRESS
0
QQ@
@
for 7 seconds
@
or(
@
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
_!ilZi>
!!!CI
iii;}i_'Zili
........iii.......
17