Filter
Top Products
Self-Cleaning
iNSTRUCTiONS PRESS DISPLAY
Stopping or interrupting a Self-Cleaning Cycle
If it becomes necessary to stop or interrupt a self-cleaning cycle
due to excessive smoke or fire in the oven:
1. Press Q.
2. Once the oven has cooled down for approximately 1 HOUR and
the "DOOR LOCKED'" icon is no longer displayed, the oven
door can then be opened (Figure 1).
Note: Self-Clean cycle can never be set to start more than 12 hours in advance.
Figure 1
Adjusting Oven Temperature
The temperature in the oven has been pre-set at the factory. When first using the oven,
be sure to follow recipe times and temperatures. Ifyou think the oven is cooking too hot
or too cool for the temperature you select, you can adjust the actual oven temperature
to be more or less than what is displayed. Before adjusting, test a recipe by using a
temperature setting that is higher or lower than the recommended temperature. The
baking results should help you to decide how much of an adjustment is needed.
Note: The oven
temperature adjustments
made with this feature will
not change the Self-Clean
cycle temperature or the
Broiltemperature.
iNSTRUCTiONS
To adjust the oven temperature higher
1. Press \B_k_,)for 6 seconds (Figure 2).
2. To increase the temperature use the number pads to enter the
desired change. (Example 30°F) _ @ (Figure 3). The _ @
temperature may be increased as much as 35°F (19°C).
3. Press to accept the temperature change and the display will or
return to the time of day (Figure 4). Press _to reject the
change if necessary.
To adjust the oven temperature lower
1 Press/"_B_ke''' for 6 seconds• 0° will appear in the display (Figure 5).
2. To decrease the temperature use the number pads to enter the
desired change. (Example -30°F) _ @ and then press @
(Figure 6). The temperature may be decreased as much as 35°F
(19°C).
3. Press :_STAR__:to accept the temperature change and the display will
return to the time of day (Figure 7). Press _ to reject the
change if necessary,
Note: The oven temperature adjustments are permanent and will stay
forever in the unit memory unless you manually change it again, Even
a power outage will not reset these changes. Follow the same
procedure again if you wish to change itto a different setting,
PRESS
Q@@
;START' or
@
DISPLAY
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
........iii.......
37