Filter
Top Products
14
Oven Controls
Adjusting Oven Temperatures
Your appliance has been factory calibrated and tested to ensure
accurate baking temperatures. For the first few uses, follow your
recipe times and temperature recommendations carefully. If you
think the oven is cooking too hot or too cool for your recipe
times, you may adjust the control so the oven cooks hotter or
cooler than the oven temperature displayed.
The oven temperature may be increased as much as +35°F
(+19°C) or decreased -35°F (-19°C) from the factory calibrated
settings.
To increase (+) or decrease (-) the oven temperature by 20°F:
1. Press and hold Bake until the control produces an audible
tone (about 6 seconds). The factory offset temperature of 0
(zero) should appear in the display.
2. Enter 2 0 using numeric keypad.
3. Press Self Clean to toggle between plus (+) if increasing
temperature or minus (-) if decreasing the temperature.
4. Press to accept change.
Important note:
• Oven temperature adjustments made will not change the
Broil or Self Clean function temperatures.
• If the temperature shows an adjustment of -20°F, and a
+20°F adjustment is needed, you can toggle between the
minus (-) or plus (+) in the display when pressing Self Clean
key (See Step 3).
• Do not use oven thermometers such as those found in
grocery stores to check the temperature settings inside your
oven. These oven thermometers may vary as much as 20°F
to 40°F degrees from actual temperatures.
• The oven temperature adjustment may be made if your
oven control has been set to display °C temperatures.
Minimum and maximum settings for °C range from plus (+)
19°C to minus (-) 19°C.
Restoring Factory Default Settings
When new, your appliance left the factory with predetermined
(default) oven control settings. Over time, users may have made
changes to these settings. The following options may have been
modified since the appliance was new:
• 12 or 24 hour display mode
• Continuous bake or 12 hour energy savings mode
• Silent or audible control
• Oven temperature display (°F or °C)
• Oven temperature adjustments
To restore oven control to factory default settings:
If you choose to restore factory default setting
using this method, all of the above user settings will be restored
to the factory default settings. This includes the oven tempera-
ture offset that will reset to (0) zero.
1. Press and hold 7 until acceptance tone sounds (about 6
seconds).
2. Press . The control has been reset with the default
settings.
Operating Oven Lights
The interior oven lights will automatically turn on when the oven
door is opened.
Press to turn the interior oven lights on and off whenever the
oven door is closed. The oven light will not operate during a
self-clean cycle.
The interior oven lights are located on the rear wall of the oven
interior and are covered with a glass shield. The glass shield
protects the bulb from high temperatures and should always be
in place whenever the oven is in use.
To replace the interior oven light, see “Replacing the oven light”
on page page 21.