Filter
Top Products
9
Oven Controls
Setting the Clock
When the appliance is first powered on, 12:00 will flash in the
display (See Figure 3). The time of day must first be set before
operating the oven.
To set clock for 1:30:
1. Press .
2. Enter 1 3 0 using numeric keypad.
3. Press .
Important note:
The clock cannot be changed when a Cook Time, Self Clean,
Delay Start, or cooking feature is active.
Setting Timer
The minute timer allows you to track your cooking times without
interfering with the cooking process. The timer may be set from
a minimum time of 1 minute to a maximum of 11 hours and 59
minutes.
To set timer for 5 minutes:
1. Press Timer Set-Off.
2. Enter 5 using numeric keypad.
3. Press . When the time runs out, END appears in the
display, and the control will beep three times every 30
seconds until Timer Set-Off is pressed.
To cancel the timer when active, press Timer Set-Off again.
Important:
• The timer does not start or stop the cooking process. It
serves as an extra minute timer that will sound an alert tone
when the set time has run out. The timer may be used alone
or while using any of the other oven functions.
• When the timer is set for more than 1 hour it will display
hours and minutes until 1 hour remains. When less than
1 hour remains, the display counts down in minutes and
seconds. With less than 1 minute remaining, only seconds
will display.
• If the timer is active during a cooking process, the timer will
show in the display. To view the status of any other active
oven function, press the key of the cooking function once
and it will appear in the display for a few seconds.
Add 1 Minute
Use the Add 1 Minute key to set additional minutes to the timer.
Each press of the key will add 1 additional minute. If the
Add 1 Minute key is pressed when the timer is not active, the
timer will activate and begin counting down from 1 minute.
To add 2 minutes to the timer:
Press Add 1 Minute twice.
Setting 12 or 24 Hour Display Mode
The clock display mode allows you to choose between the 12 or
24 hour modes. The factory pre-set clock display mode is
12 hours.
To set 12 or 24 hour display mode:
1. Press and hold for 6 seconds.
2. Press Self Clean to toggle between 12 Hr day or 24 Hr day
display modes (See Figure 4 and Figure 5).
3. Press to accept choice.
Changing Between Continuous Bake Setting or 12 Hour
Energy Saving Feature
The oven control has a factory preset 12 hour energy saving
feature that will turn off the oven after 12 hours. The control may
be programmed to override this feature to bake continuously.
To change between continuous bake or 12 hour energy saving
feature:
1. Press and hold Timer Set-Off for 6 seconds
2. Press Self Clean to toggle between 12 Hour OFF (Figure 6)
or Stay On (Figure 7) feature.
3. Press to accept choice
.
Figure 3: 12:00
Figure 4: 12 Hr dAy Figure 5: 24 Hr dAy
Figure 6: 12 Hr Off Figure 7: Stay On