Filter
Top Products
Self-Cleaning
• Setting Flex Clean
• Setting Delay Flex Clean
INSTRUCTIONS
When the Self=Clean cycle is done:
1. The time of day,"Not, DOOR LOCKED" and "CLEAN" icon will
remain in the display (See Fig. 7).
2. Once the oven has cooled down for approximately 1 HOUR, and
the "DOOR LOCKED" icon is no longer displayed, the oven
door can then be opened.
PRESS DISPLAY
Fig.7
Stopping or Interrupting a Self=Cleaning cycle:
If it becomes necessary to stop or interrupt a Self-Cleaning cycle
due to excessive smoke or fire in the oven:
1. Press_.
2. Once the oven has cooled down for approximately 1 HOUR and
the "DOOR LOCKED" icon is no longer displayed,the oven door Fig.8
can then be opened (Fig. 8).
IMPORTANT NOTES when using the Self-Clean feature:
1. Do not use the surface burners after setting for a Self-Clean cycle.
2. A Self=Clean cycle cannot be started if Oven Lockout feature is active.
3. If a Self-Cleaning-Cycle has started but not finished and a power failure occurs, the appliance may not have thoroughly
cleaned. Once power is restored, set for another Self-Clean cycle to finish.
4. If your clock is set for normal 12 hour display mode the Delay Self=Clean cycle can never be set to start more than 12
hours in advance. To set for Delay Flex-Clean 12-24 hours in advance see page 13 for instructions to set the control for the
24 hour time of day display mode.
iii..............
..........iii.........
33