Filter
Top Products
Self-Cleaning
* Setting Flex Clean or Delay Flex Clean
The FLEX CLEAN _'_ pad is used to start a Self-Cleaning cycle. When used with the DELAY START (,_x)
pad,
a
delayed Self-Cleaning cycle may also be programmed. The FLEX CLEAN feature allows for any Self-Cleaning cycle time
from 2 (2:00) to 4 hours (4:00) to be selected. You may also choose the clean time in 1 minute increments (for example 2
hours and 50 minutes) by pressing the number keypads
During the Self-Cleaning cycle, the outside of the range can become VERY HOT to the touch. DO NOT
leave small children unattended near the appliance.
DO NOT force the oven door open. This can damage the automatic door locking system. Use care when
opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or
steam to escape. The oven may still be VERY HOT.
INSTRUCTIONS PRESS DISPLAY
To start an immediate Self-Cleaning cycle or to set a Delay Start
time of 9:00 o'clock and shut=off automatically (example
provided isa default 3 hour Self-Clean cycle):
1. Be sure the clock is set with the correct time of day, the oven
is EMPTY and the oven door is closed.
2. Press _ . "CLEAN" will flash, "3:00" (hours) and the
Cooktop locked icon will show in the display (See Fig. 1). 2-4
hours of Self-Cleaning time may be choosen by pressing any
amount of time from _@@ (2 hours) through
( bdbdb (4hoors ,nono ,noto,ncro nts
may also skip the time entry and accept the default cleaning
time of 3 hours by pressing the START key pad (See Step 3).
3. Press _'_ .The "DOOR LOCKED" icon will
flash; "CLEANg'
Cooktop Lockout icon and the letters "CLn" will remain on in
the display (See Fig. 2).
4. As soon as the control is set, the motor driven oven door lock
will begin to close automatically. Once the door has been
locked the "DOOR LOCKED" indicator light will quit flashing
2:00 thru 4:00 using Fig.1
number pads
Fig. 2
Fig. 3
NOTE: if the optional delay Self-Clean feature is needed, finish steps 5=7. If Self-Clean is started immediately skip the remaining
steps and continue with "When the Self-Clean cycle is done" on the following page.
and remain on. The Cooktop locked icon will remain on (Fig. 3).
5. Press d_ (See Fig. 4). Enter the desired Self-Clean starting
time using the number pads @@@ (See Fig. 5).
6. Press _. "CLn" icon will turn off; "DELAY", "DOOR
LOCKED", "CLEAN" and Cooktop locked iconswill remain on.
7. The control will calculate forward from the set start time to
determine when the Self-Cleaning cycle should end. The Self-
Cleaning cycle will turn on automatically at the set time. At that
time the icon "DELAY" will go out; the oven icon will come on,
the start time, Cooktop locked icon, "CLEAN" and "CLn" will
remain in the display (See Fig. 6).
Fig. 4
31
Fig. 5
Fig. 6