Filter
Top Products
1
continuedfrompage8
Cut a 3/4" (1.9cm) hole (_ in right-hand
cabinet side, rear or floor. Optional
locations are shown.
Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with
Grommet (Part No. 302797) available
from your Sears store or service center.
4.
Run wire into house wiring junction
box. Usestrain relief method provided
with junction box. If no strain relief is
provided, install a U.L.-listed/CSA-
certified clamp connector for flexible-
type wire. If installingconduit, attach a
U.L.-listed/CSA-certified conduit
connector to junction box.
m
6"(15,2cm)
Run other end of wire through cabinet
hole. Cable must extendto the right
front of cabinet opening. Go to step 6.
Cut a 1-1/2" (3.8cm) hole _) in right-
hand cabinet rear or side. Optional
locations are shown.
Wood cabinet: Sand hole until smooth.
Metal cabinet: Cover hole with
Grommet (Part No. 302797) available
from your Sears store or service center.
4a,
Install a mating, three-prong,
grounding-type wall receptacle _ in the
cabinet next to the dishwasher opening.
Go to step 6.
9