Filter
Top Products
continuedfrompage4
Electrical
It is the customer's responsibility:
To contact a qualified electrician.
To assure that the electrical
installation is adequate and in
conformance with all national and
local codes and ordinances.
You must have:
I/120-volt, 60-Hz, AC-only,15- or
20-amp., fused electricalsupply.
i/COPPER WIRE ONLY.
We recommend:
v' a time-delay fuse or circuitbreaker.
a separate circuit.
iv' use flexible, armored or non-metallic
sheathed, copperwire with
grounding wire that meets the wiring
requirements for your home and
local codes and ordinances.
use strain relief method provided
with house wiring junction box or
install a U.L.-listed/CSA-oertified
clamp connector to the house wiring
junction box. If using conduit, use a
U.L-listed/CSA-certified conduit
connector.
v' use Power Supply Cord Kit (Part No.
4317824) available from your Sears
store or service center. Follow the kit
instructions for installing the power
supply cord.
If kit is unavailable, use a U.L.-listed,
16-gauge, three-conductor power
supply cord that meets all local
codes and ordinances. Maximum
length of the power supply cord is
6 feet (1.8m).
a clamp connector to fit a 7/8"
(2.2cm) diameter hole is required to