Filter
Top Products
10.
continuedfrompage10
Drain hose
Cut a 1-1/2" (3.8cm) diameter holein
cabinet wall or floor on the side of the
opening closest to the sink.
Connectdrain hose to waste tee or
waste disposer following one method.
11.
Ifyouhave: and:
an airgap
a wastedisposer
noairgap*
anair gap
nowastedisposel
noair gap*
*an airgapisrecommended
gotostep:
11a.
11c.
11b.
11d.
11a.
1. Remove the disposer knockoutplug.
Cut end of drain hose O if needed
(do not cut ribbed section).
2. Attach drain hose to air gap • with
spring-type clamp O.
3. Use a rubber hose connector* •
with spring or screw-type clamps*
_) to connect air gap to disposer
inlet O.
This connection O MUST be before
drain trap _) and at least 20" (50.8cm)
above the floor where dishwasher will
be installed. Go to step 12.
11b.
1. Cut end of drain hose O if needed
(do not cut ribbed section).
2. Attach drain hose to air gap O with
1-!/2"-2" (3.8-5cm) screw clamp.
3. Use a rubber hose connector* •
with spring or screw-type clamps*
_) to connect air gap to waste tee _).
This connection _ MUST be before
drain trap (D and at least 20" (50.8cm)
above the floor where dishwasher will
be installed. Go to step 12.
11