Filter
Top Products
29
Changing Oven Light
Be sure the oven is unplugged and all parts
are COOL before replacing the oven light bulb. Do not
turn the oven light on during the self-cleaning cycle. High
temperature will reduce lamp life.
On some models an interior oven light will turn on auto-
matically when the oven door is opened.
The oven light may be turned on when the door is closed by
using the oven light switch located on the control panel.
On a self clean oven the lamp is covered with a glass shield
held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE
OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL
1. Turn the power o at the main source.
Front Frame
Roller
Guide
Roller
Storage
Drawer
Storage Drawer
Use the storage drawer for storing cooking utensils. The
drawer can de removed to facilitate cleaning under the
range. Use care when handling the drawer.
Removing and Replacing Storage Drawer
To remove the drawer:
1. Pull empty drawer out to the roller guide stop.
2. Tilt the drawer up and pull it out over the rollers.
To replace the drawer:
1. Insert the rear end of the drawer into the opening.
2. Fit the drawer end rollers onto the guide rails.
3. Push the drawer in until it stops, then lift to allow the rollers
to clear the roller guide stop, and push in.
Roller pin
Hinge arm notch
Hinge arm hook
Slot bottom
Care & Cleaning
Door Hinge
locations
with oven door
fully open
Figure 1
Figure 2
Figure 3
Figure 4
Oven door
Around
Hinge
2. Wear a leather-faced
glove for protection against
possible broken glass.
3. Replace bulb with a 40 watt
appliance bulb only.
4. For self-cleaning oven, press
wire holder to one side to
release glass shield, change
bulb and be sure to replace
glass shield.