Filter
Top Products
- CARE OF YOUR REVERSE OSMOSIS SYSTEM -
TUBING CONNECTION (continued)
AUTOMATIC SHUTOFF SERVICE
To Disconnect Tubing: Push the collet inward and
hold with a finger while pulling the tubing out.
FIG. 11-A]
cut tubing _uare
L 1
I I
I
end of tubing round and
smooth, with no cutS,
nicks or flat spots
Tubing correctly cut and connected
oollet _._
11/1_' {1N" ub
FIG. 11-B]
collet (depress to
remove,tubing)
Replacing collct and
o-ring seal
Push o-ringseal into
bottom of port, then
fellow with collet.
_ltting
collet
Changing CoUet and O-ring (FIG. 11):
1. VClth a small screwdriver remove the coUet and o-
ring from the fitting, Be careful not to scratch the in-
ternal walls of the coUet port.
2. Be sure the port is dean, then lubricate and insert
the o-ring seal to the bottom of the port.
3. Push the collet inward until it locks in :place,
r 1
I CAUTION I
[ [
[ CLEANERS ON THIS RO SYSTEM. THEY WILL [
[ DEGRADE SOME Re SYSTEM PARTS, ALWAYS [
[ USE SOAP AND WATER. [
I. .................... J
r
[ This reverse osmosis system contains a replaceable [
[ treatment componertt critical for effective removal [
[ of total dissolved solids. The water should be tested [
[ periodicallytoverifythesystemisperformingsatis- [
[ factorily. I
I. .................... J
If the shutoff assembly requires service, be sure to
reassemble parts exactly as shown in FIG. 12.
FIG. 12 ]
SHUTOFF
screw (4) ASSEMBLY
diaphragm
plunger
spacer ring
diaphragm
%. J
o-ring
14
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line
check
vaJve