Filter
Top Products
- STEP 5: INSTALL STORAGE TANK,
MAKE REMAINING TUBING CONNECTIONS -
1. CONNECT DRAIN TUBING, FAUCET TO
DRAIN ADAPTER: Referring to FIG. 8, run the loose
section of black 3/8" tubing from the faucet to the
drain adapter, with a black collet, installed on page
6. Cut this tubing as needed to route in as straight of
a run as possible, without loops, dips, low spots or
kinks. Cut the end of the tubing square. Then push
all the way into the fitting. Pull on the tubing to be
sure it's held firmly in the adapter fitting. See pages
13 and 14 for tubing connection instructions.
2. CONNECT TUBING TO WATER SUPPLY: Con-
nect the feed (green) tube to the water supply fitting
installed on page 5. Connection to the fitting is as de-
scribed in Fig. 11, page 14.
3. Move the storage tankinto place next to the RO as-
sembly. You can stand the tank upright, or lay it on
side. Apply no more than two wraps of Teflon tape
to the threads on the nipple at the top of the tank.
Hand tighten the other included tubing adapter fit-
ting with the yellow collet onto the tank nipple, then
wrench 1/4 turn only. BE CAREFUL NOT TO
CROSS THREAD.
4. Run the 3/8" yellow tubing to the fitting installed
in step 3. Be sure the end of the tubing is cut square,
and insert all the way into the fitting. Again, pull on
the tubing to be sure it's held firmly in the fitting.
FIG. 8 ]
TYPICAL UNDERSINK INSTALLATION
RO prod ucl:
water faucet
3/8" BLACK TUBING
water supply
fitting
HOT CeLD
tubing adapto_ yellow toilet
\
drain
adap_r
Note: See note on page 4
regarding tubing lengths.
telephone cable
""sink p-trap monitored models
only
8
Problems, Questions? Call 1-800-426-9345 Kenmore Water Line