Kenwood TTM310 Toaster User Manual


 
To toast bagels the cut face should
be facing the front of the toaster.
Note: when toasting using the bagel
button, the front element will toast
with a higher heat than the element
at the back of the toaster. This will
result in only one side of the
item being toasted.
You can use the carriage lever to lift
the food item to Peek & View™ at
any time without cancelling.
7To stop toasting at any stage, press
the cancel button. The toaster will
emit an audible beep to indicate
toasting is cancelled and the button
lights will go out.
8 When toasting is nearly finished the
toaster will emit an audible beep and
after a slight delay the button lights
will go out and the toasting will stop.
The food item will NOT pop up.
9 Use the carriage lever to raise the
food item.
10 After use, unplug the toaster.
using the tongs
Unplug the toaster, use the carriage
lever to raise the food item and use
the tongs to assist with the removal
of particularly small items such as
scotch pancakes or crumpets.
CAUTION: Avoid touching the
metal parts with the tongs.
to toast food items
using the sandwich
cage
Thoroughly cook or re-heat
ingredients such as meat or
fish prior to adding them to
the food item and ensure all
ingredients are piping hot
throughout before serving.
Do not re-heat ingredients
more than once.
Do not leave hot ingredients
to cool before toasting the
food item.
Ensure all ingredients
particularly meat or fish are
fresh and used within use-by
dates.
Use other vegetable ingredients
at room temperature to avoid
them chilling the hot cooked
ingredients.
When cutting your paninis or
ciabattas etc do not cut all the way
through, instead leave the bottom
side uncut so that it prevents melted
cheese from dripping into the toaster.
Cut ingredients thinly - do not use
large chunks.
Take care when using ingredients
that could melt and run out of the
food item. We do not recommend
the use of high fat or similar fillings
that may drip into the toaster as this
will be difficult to clean.
Lightly butter the outside surface of
sandwiches and place the filling in
between the unbuttered sides. This
helps prevent the outside from
burning. Do not use low fat spreads,
which are not suitable for toasting.
Ensure the food item is evenly filled.
Always use food items that are a
suitable size for the sandwich cage.
Do not force food items into the
toaster.
1 Plug the toaster into the power
supply, an audible beep will be heard.
2 Place the food item in the sandwich
cage and close.
3 Adjust the slot width to suit the
sandwich cage . CAUTION:
Take care not to touch the
fascia panel, it may be hot.
4 Lower the carriage lever and
place the sandwich cage into the
slot with the handle pointing to
the opposite end to the controls.
5 Move the browning control to the
desired setting.
6 Select the desired button (i.e. low
power). The selected button and
cancel button lights will illuminate, an
audible beep will be heard and
toasting will begin.
4