Keurig B150 Coffeemaker User Manual


 
7
4. At the end of the 40 minutes, lower the handle and the brewer should complete
the brew (do not be concerned if the brewer does not complete the brew). Pour
the dispensed liquid into the sink.
5. Shut down the brewer, disconnect it from AC power, and drain both (Hot and
Cold) water tanks using the drain tubes located in the back panel of the brewer.
CAUTION: Hot water will be exiting from the Hot Water Tank
6. Manually fill the Cold Water and allow to drain tank three times, using 40 ounces
fresh water per fill. Replace Drain Tube Plugs and Access panel.
7. Reconnect or resume city water supply and power up the brewer.
8. Once the brewer is filled and hot, conduct large volume “Water Only” brews,
with no K-cup potion pack in place, until all remnants of the descale solution are
not longer evident discarding all liquids into the sink. We suggest using the
largest brew size to speed the process. Remember to open and close the brew
handle between each cycle so the blue Brew lights will flash.
9. Place the brewer back into service.
You may need to perform additional rinse cycles if you notice any residual taste.