Filter
Top Products
Top front
of refrigerator
Freezer
door
Refrigerator
door
C
D
B
A
Door swing dimensions
If a solid soffit 1” (2.5 cm) max. above refrigerator is not
available, prevent the refrigerator from tipping during
use, as shown.
Securely attach a 32” (81 cm) long min. wood board(s) to
wall studs behind refrigerator. The wood screws must be
screwed into the studs 1-1/2” (3.8 cm) min. The board(s)
must overlap the compressor cover as shown.
If additional ceiling clearance is required for tipping the
refrigerator, follow the directions for your model.
For wraparound metal models:
• Grasp both ends of the louver panel. Push straight up,
then pull out and remove.
• Remove the two screws attaching grille panel, slide the
grille panel down and remove.
• Remove the six screws attaching each cabinet side trim to
the refrigerator and remove the side trims.
• Reassemble after dolly has been removed from refrigerator.
For panel models:
• Grasp both ends of the panel. Push straight
up, then pull out and remove.
• Remove the four screws attaching the frame
to the brackets and remove.
• Remove two screws attaching each bracket
to the refrigerator and remove
• Reassemble after dolly has been removed from refrigerator.
Board(s) must be long enough to fully
cover width of compressor cover.
It is recommended that board(s) be
installed before refrigerator is installed.
Locate the board(s) so the bottom surface
of the board(s) are 84” (213 cm) from the
floor. During installation, raise the
refrigerator up so there is 1/4” (6.4 mm)
max. between top of the refrigerator and
bottom of anti-tip board(s).
DO NOT crush the condenser cover when
raising the rear leveling legs.
1/4" (6.4 mm)
max.
2" (5.1 cm)
min.
rear
wall
Page 4
Anti-tip requirements
Tipping radius
Forward/backward
tipping radius
Side
tipping radius
Size A B
36" (91 cm) 87-1/4" (222 cm) 90-1/2" (230 cm)
42" (106 cm) 87-1/4" (222 cm) 93" (236 cm)
48" (122 cm) 87-1/4" (222 cm) 96" (244 cm)
A
B
A
B
C
D
E
F
36"
91 cm
38-1/2"
(98 cm)
36-1/16"
(92 cm)
43-1/2"
(110 cm)
40"
(102 cm)
19-3/4"
(50 cm)
14-1/2"
(37 cm)
42"
106 cm
41"
(104 cm)
38"
(97 cm)
47"
(119 cm)
42-9/16"
(108 cm)
23-1/4"
(59 cm)
17-1/4"
(44 cm)
48"
122 cm
43-1/2"
(110 cm)
40"
(102 cm)
50-1/2"
(128 cm)
45-1/4"
(115 cm)
26-3/4"
(68 cm)
19-3/4"
(50 cm)
Location must permit doors to open to 110°
min. Allow 4-1/2 inch (11.4 cm) min. space
between refrigerator side and corner wall.
130°
130°
90°
90°
E
F
Note: Dolly wheel height must be added to tipping
radius when a dolly is used.
110°
110°
bracket
screws