Filter
Top Products
CHANGING
TI-IE BIN DOOR AND LOWER PANEL
The slorage bin door and lower panel are deslgned to
accept an oplional decorative wood panel of your
choice.
The wood panel should be no more than j/4 Inch (6.35 mm)
Ihick. GUI il lo the same size as Ihe production
I
DOOR
LOWER
BIN PANEL
Tf
11 %” 11’%8”
panel. See Figure 1.
(28.6 cm) (30.3 cm:
To change the bin door panel.
1. Open the bin door.
2. Remove the two screws on lop of the door which
hold Ihe handle.
3. Remove the handle.
4. Slide the metal panels out.
5. Break off the ribs on the door insulalion to allow
for the wood thickness. See Figure 2
6. Slide the wood panel into the door frame.
7. Replace handle and acraws.
To change the lower panel:
-
PANEL
DIMENSIONS
b(43.2 cm)-
FIGURE 1
1. Hemwe the two screws at the txttom that hold the
lower panel assembly to the ice maker
2. Remove the Iwo acraws on the top of the pane!
assembly.
REMOVE ALL DOOR INSULATION
RIBS TO ACCEPT WOOD PANEL
THICKNESS
FIGURE 2
3. Slide the metal panels and spacers 01~1.
4. Slide the wood panel into Ihe door frame.
5. Replace the top of the panel assembly
NOTE: Make sure the galvanized panel is replaced I”
back of the panel assembly.
If ice maker is installed above two thousand feet of
altitude, the bin and evaporator thermostats must
be adjusted to a warmer setting. Disconnect
electricity,
remove thermostat and follow the
directions for turning the altitude adjustment
screw as shown in the label on each thermostat.
SHIPBOARD OPERATION
When this ice cube maker is installed aboard a ship,
it will be necessary to purchase and install a water
deflector. This deflector hanas between the lower
edge of the evaporator and the cutter grid. It keeps
the water flowing over the evaporator from spilling
into the storage bin area. Order the necessary parts
from your local ice maker dealer.
2