Filter
Top Products
6
3.
The water shut-off should be located in the base cabinet on
either side of the refrigerator. The right-hand side is
recommended. The access hole through the right cabinet
must be within
¹⁄₂
in. (12.7 mm) of rear wall.
4.
A
¹⁄₂
in. (12.7 mm) hole for plumbing should be within the
bottom shaded area (see the “Connect Water Line to
Refrigerator” section). Water line can be through floor or wall.
If the recommended water line location is used, no additional
plumbing needs to be purchased.
Width of Opening:
Location Requirements
NOTES:
■
Do not install the refrigerator near an oven, radiator, or other
heat source, nor in a location where the temperature will fall
below 55°F (13°C).
■
Floor must support refrigerator weight, more than 600 lbs.
[272 kg], door panels and contents.
■
Ceiling height must allow for side or front tipping radius (see
the “Tipping Radius” section).
■
Location should permit doors to open fully. See the “Door
Swing Dimensions” section.
Electrical Requirements
Before you move your refrigerator into its final location, it is
important to make sure you have the proper electrical
connection:
1. Stud location
2. Grounded electrical outlet location
3. Recommended water shutoff valve location
4. Plumbing hole and water line location (wall or floor)
Model Width A (as shown above)
36 in. (91.4 cm)
42 in. (106.7 cm)
48 in. (121.9 cm)
35
¹⁄₂
in. (90.2 cm)
41
¹⁄₂
in. (105.4 cm)
47
¹⁄₂
in. (120.7 cm)
80" - 90"
(203-229 cm)
4"
(10.2 cm)
6"
(15.2 cm)
3" (7.6 cm)
83
1
/4" (211.5 cm) min.
84
3
/4" (215 cm) max.
to bottom of solid soffit.*
23
1
/2"
(60 cm) min.
11"
(28 cm)
77"
(196 cm)
A
Width
(see chart following)
1
2
4
6"
(15.2 cm)
6"
(15.2 cm)
3
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from refrigerator.
Failure to do so can result in death, explosion,
or fire.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Do not use an extension cord.
Do not use an adapter.
Do not remove ground prong.