Filter
Top Products
8
9.Connect clear tubing from spout
to center tank tubing using clamp.
Make sure clear tubing does not kink.
10.Install saddle valve following
kit instructions. If water supply line is
not copper, shut off water supply and
drain line. Drill a 1/4" (6.4 mm) hole
into water supply line for the saddle
valve piercing pin.
11.Turn saddle valve handle
clockwise until lance pierces soft
copper tubing and valve is firmly
seated. If the water line is not copper,
turn the saddle valve handle
clockwise until the valve is firmly
seated. The valve is now in the
closed position.
Place a bucket under open end of
water supply line. Turn on main water
supply valve to pressurize cold water
line. Check for leaks.
12.Slowly open saddle valve and
flush line into bucket to remove any
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.
8.Connect 1/4" (6.4 mm) spout
tubing (longer tubing) to the rear
quick-connect fitting on top of tank.
Push tubing straight into fitting as far
as it will go. Pull on tubing. The
tubing should not come out when
properly installed.
Do Not lengthen, twist or tightly
bend tubing.
quick-
connect
fitting
clear
tubing
clamp
closed
open
NOTE: Do NOT plug power supply cord into outlet.
Installation Instructions
cont.