Filter
Top Products
16
How the Cycle Works
IMPORTANT:
The heating and cooling of porcelain on steel in the
oven may result in discoloring, loss of gloss, hairline cracks and
popping sounds.
The Self-Cleaning cycle uses very high temperatures, burning soil
to a powdery ash.
The oven is preset for a 3 hour 30 minute clean cycle, however
the time can be changed. Suggested clean times are 2 hours 30
minutes for light soil and between 3 hours 30 minutes to 4 hours
30 minutes for average to heavy soil.
Once the oven has completely cooled, remove ash with a damp
cloth.
The oven light will not work during the Self-Cleaning cycle.
On combination oven models, the upper oven will not work
during the Self-Cleaning cycle.
To Self-Clean:
Before self-cleaning, make sure the door is closed completely or
it will not lock and the cycle will not begin.
1.
Press CLEAN.
Press the number pads to set a clean time other than 3 hour
30 minutes. The clean time can be set between 2 hours 30
minutes and 4 hours 30 minutes.
2.
Press START.
The lower oven door will automatically lock and “DOOR
LOCKED”, the start time and stop time will appear on the
lower oven display. The door will not unlock until the lower
oven cools.
When the cycle is complete and the oven cools, “End” will
appear on the lower oven display and “DOOR LOCKED” will
disappear.
3.
Press any pad or open the lower oven door to clear the lower
oven display.
To Delay Start Self-Clean:
Before delay starting Self-Clean, make sure the clock is set to the
correct time of day. See “Clock” section. Also, make sure the
door is closed completely or it will not lock and the cycle will not
begin.
1.
Press CLEAN.
Press the number pads to set a clean time other than 3 hour
30 minutes. The clean time can be set between 2 hours 30
minutes and 4 hours 30 minutes.
2.
Press STOP TIME.
3.
Press the number pads to enter the time of day to stop.
4.
Press START.
The start time is automatically calculated and displayed.
The door will automatically lock and "DOOR LOCKED",
"DELAY", and the stop time will also appear on the display.
The door will not unlock until the oven cools.
When the start time is reached, the lower oven will
automatically turn on.
When the cycle is complete and the oven cools, “End” will
appear on the lower oven display and “DOOR LOCKED” will
disappear.
5.
Press any pad or open the lower oven door to clear the oven
display.
To Stop Self-Clean any time:
Press LOWER OVEN CANCEL. If the lower oven temperature is
too high, the door will remain locked. It will not unlock until the
lower oven cools.
Cleaning
IMPORTANT:
Before cleaning, make sure all controls are off and
the oven is cool. Always follow label instructions on cleaning
products.
Soap, water and a soft cloth or sponge are suggested first unless
otherwise noted.
STAINLESS STEEL
(on some models)
Do not use soap-filled scouring pads, abrasive cleaners, Cooktop
Polishing Creme, steel-wool pads, gritty wash cloths or some
paper towels. Damage may occur.
Rub in direction of grain to avoid damaging.
■ Stainless Steel Cleaner & Polish (not included):
See “Assistance or Service” section to order.
■ Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.
■ Vinegar for hard water spots
OVEN DOOR EXTERIOR
■ Glass cleaner and paper towels or non-abrasive plastic
scrubbing pad
CONTROL PANEL
Do not use abrasive cleaners, steel-wool pads, gritty wash cloths
or some paper towels. Damage may occur.
■ Glass cleaner and soft cloth or sponge:
Apply glass cleaner to soft cloth or sponge, not directly on
panel.
OVEN CAVITY
Do not use commercial oven cleaners.
Food spills should be cleaned when oven cools. At high
temperatures, foods react with porcelain and staining, etching,
pitting or faint white spots can result.
■ Self-Cleaning cycle:
See “Self-Cleaning Cycle” first.
OVEN RACKS
■ Self-Cleaning cycle:
See “Self-Cleaning Cycle” first. Racks will discolor and
become harder to slide. After cleaning, a light coating of
vegetable oil applied to the rack guides will help them slide.
■ Steel wool pad