Filter
Top Products
24
Surface and Night Light
(on some models)
SURFACE LIGHT
The cooktop light is a 20-watt cool-white fluorescent tube, and
has 2 replaceable parts. The starter is a knob-shaped part located
on the right side of the backguard, under the light bulb.
Before replacing, make sure the range is off and cool.
The cooktop light is located in the backguard. It is controlled by
the SURFACE LIGHT command pad on the control panel. The ON
pad turns the light on immediately and keeps the light on until
OFF is pressed.
To Use:
1.
Press SURFACE LIGHT/ON to turn on cooktop light.
2.
Press SURFACE LIGHT/OFF to turn off cooktop light.
NIGHT LIGHT
The NIGHT light is located in the backguard. The NIGHT
command pad will turn on the SURFACE LIGHT automatically
when the light in the room is low enough to require a night light.
When the night light is turned on, it will dim all lights appearing on
the display.
To Use:
1.
Press SURFACE LIGHT/NIGHT to turn on.
“NIGHT LIGHT” will show on the display.
2.
Press SURFACE LIGHT/NIGHT to turn off.
To Replace Light:
1.
Unplug range or disconnect power.
2.
Flip up the top of the backguard.
3.
Pull up glass on front of backguard.
4.
Grasp both ends of the fluorescent tube.
5.
Turn the tube 90° in either direction until both ends come out
of the receptacles.
6.
Replace tube, replace top of the control panel.
7.
Plug in range or reconnect power.
To Replace Starter:
1.
Unplug range or disconnect power.
2.
Remove tube.
3.
Push starter in and turn approximately 90° counterclockwise.
4.
Pull starter out of recessed area.
5.
Replace starter, tube and top of control panel.
6.
Plug in range or reconnect power.